60beat BLUE Manual

60beat®
Congratulations on your purchase of the 60beat BLUE
heartrate monitor.
THIS PRODUCT REQUIRES:
1. The 60beat BLUE Heart Monitor
2. An iPhone 4S, The New iPad (known as iPad 3) or
compatible Bluetooth Smart enabled device (Android
devices being added)
3. An application that is compatible with the 60beat
BLUE (a list of compatible Apps is maintained at
www.60beat.com)
BASIC STEPS: (For more details, look at DETAILED STEPS)
1. Download the 60beat heart rate monitor application
on your iPhone – (or other 60beat BLUE supported App)
2. Put on the heart rate monitor chest strap -
remember to wet the sensors on the back of the strap.
3. Turn on Bluetooth on your iOS device
4. Open the App
5. Pair 60beat BLUE with device
6. Start your workout
60beat HEART RATE APP - PAIRING
Download the 60beat Heart Rate
Monitor App – Free
Find the settings tab in the upper
right hand corner and press
Press the Configure Bluetooth
button for pairing
On the Settings page you can also
adjust the heart zones and preferred
e-mail address for sending data
Make sure that Bluetooth is enabled
Make sure you have the chest strap
on and the sensor areas wet
Tap the available device you wish to
pair with and return to settings
In settings, hit Save and then Back
MORE DETAILED STEPS:
1.Download the 60beat Heart Rate Monitor App
2.Put the 60beat BLUE Strap on. Wrap the strap around
your torso just below your breast bone. Adjusting the
elastic strap to provide a snug fit. Be sure to wet the
sensor area between the soft rubber like material and
your chest. The fluid helps to make an electrical
contact with your chest to detect the heart beat signal.
3.Make sure the Bluetooth is set on your iPhone. Settings
> General > Bluetooth. Slide to the On position. You
will see the Bluetooth symbol in the upper right next to
the battery indicator.
4.Open the fitness App you wish to use. Locate "add a
new sensor" and follow the instructions provided by
the App. It is best to pair your 60beat BLUE chest strap
away from any other device that might use the same
signal. If you pair your device more than 30 meters
from any other device, this should be sufficient. Once
the device is paired, you can operate the device in
close proximity to another device without interference.
The technology is able to filter out those other signals
once the units are paired.
5. Within the App, start the "Log" a fitness activity. It can
take up to 60 seconds for the App to start showing an
actual BPM (beats per minute) reading. Please wait
for this value to begin showing in the application. If
you are not seeing a BPM reading, we suggest killing
all other Apps that may be using the Bluetooth connection.
This can be done by double clicking the home button.
Press and hold the App until the red circle appears on
the upper left of the App. Then press the red circle.
Then try step 4 and 5 again.