Operation - RedMax HEZ2460S Owner's/Operator's Manual

HEZ2460S/HEZ3060S

8. Operation

The RedMax stick edgers are designed
for edging lawn in gardens, parks,
roadsides and so on.
Before starting the engine, take the
operating position and adjust the handle
position and the wheel height as
necessary.
■ ADJUSTING WHEEL HEIGHT
OP1 1. Loosen the wing nut and change the
wheel height to obtain desired cutting
depth. (OP1)
(1)
(1) Deep cut
(2)
(2) Shallow cut
(3)
(3) Wing nut
2. After adjusting the height, tighten the
wing nut securely.
• Never adjust wheel height with the
engine running.
US-12
Tightening Torque:
51~68in-lbs (6~8N.m.)
WARNING
■ STARTING ENGINE
The cutting head will start rotating
upon the engine starts.
1. Rest the unit on a flat, firm place. Keep
the cutting head off the ground and
clear of surrounding objects as it will
start rotating upon starting of the
engine.
OP2
2. Push the primer pump several times
until overflown fuel flows out in the
clear tube. (OP2)
3. Move the choke lever to the closed
OP3
position. (OP3)
(1)
(1) choke lever
(2)
(2) close
(3) open
(3)
4. Set the stop switch to the "RUN"
OP4
position. Place the unit on a flat, firm
(3) place. Keep the cutting head clear of
(2)
everything around it. (OP4)
(1) stop switch
(a)
(1)
(2) RUN
(3) STOP
(a) lockout lever
(b)
(b) throttle trigger
5. Firmly grasp (a) and (b) with left hand
OP5
(OP4), pull the starter knob quickly until
engine fires. Release throttle trigger
after engine starts. (OP5)
• Avoid pulling the rope to its end or
returning it by releasing the knob. Such
actions can cause starter failures.
6. Move the choke lever downward to
open the choke. And restart engine.
(OP3)
7. Allow the engine to warm up for several
minutes before starting operation.
WARNING
IMPORTANT