Stone Forest Siena Recesso SI-IN-36 Installation

Siena Recesso, Lastra and Trucco Installation (#'s SI-IN-36, SI-CS-36, SI-MK-36)

Please read these instructions carefully before you begin. Also, review the recommended tools

section and lay out all components to assure you have the correct tools, items and quantities needed

for proper installation.

Note: The Siena Collection is designed to be installed on a flat and level surface. Any variation in this will

require the use of shims. It will also add time to the installation.

Caution! Stone sinks, countertops and vanities are very heavy. Please use care and caution when handling.

Important: Do not use an oil-based sealer, silicone, or plumbers putty. These products will stain if applied

near the surface. Use a latex-based caulk recommended for use with tile and stone.

All installation procedures must comply with all applicable local plumbing and building codes.

Required tools:

Material Lift

Drill/driver

Additionally for the Recesso Sink, #SI-IN-36:

Adhesive Caulk/Sealant such as DAP Qwikseal

Wood Screws #8 x ¾"L(x6)

Machine Screws ¼"-20 x ¾"L(x18)

Level

5 minute clear epoxy

Tape Measure

Wood blocks

Henkels Polyseam Seal

Rubber Mallet

Short handled philips screwdriver

Table of Contents

Do you have a question about the Siena Recesso SI-IN-36 and is the answer not in the manual?

Page 1 Siena Recesso, Lastra and Trucco Installation (#’s SI-IN-36, SI-CS-36, SI-MK-36) Please read these instructions carefully before you begin. Also, review the recommended tools section and lay out all components to assure you have the correct tools, items and quantities needed for proper installation.
Page 2 Instructions: SI-CS-36, Lastra Console 1. Carefully position legs in desired location. The legs and top are marked indicating right and left, as well as front/back. Be sure to set the legs in the correct orientation to the top. Leave about 30” between the legs and check for level and plumb.
Page 3 Fig. 1 Fig. 2 Sizes and weight capacities of lifts vary by rental location and company. Confirm that the rental company can supply one that will fit in the bathroom where the Siena is being installed and also between the legs of the unit. Fig.
Page 4 Fig. 5 Fig. 6 Fig. 7 Care & Maintenance: -Wipe the stone dry with a soft cloth after each use. -Clean regularly with a granite & marble cleaner, such as Marbamist by Stone Care International. If a household cleaner is used, it must specifically state ‘safe for marble’, and have a neutral pH of 7.0. Use of any other product may alter the effectiveness of the sealer.

Siena lastra si-cs-36Siena trucco si-mk-36