Summary of Contents for Imetric D10 Series
- Page 1 D10x Setup Guide - o O o - Imetric 3D GmbH Le Bourg 9 CH – 2950 Courgenay Switzerland T.: +41 324 711 409 www.imetric.com...
-
Page 2: Table Of Contents
Table of Content 1 TABLE OF CONTENT ......................2 2 INTRODUCTION ......................... 3 3 UNPACKING ........................3 4 ACCESSORIES ........................4 5 CONNECTIONS ........................5 6 DISPLAY CONFIGURATION ..................... 6 7 SCANNER PROJECTOR ADJUSTMENT ................. 7 D10x_Setup_Guide_20111202 Page 2 of 8 January 10, 2012... -
Page 3: Introduction
Introduction This guide will provide you with the beginning information to connect your IScan scanning system. It supposes the computer has already been properly installed and configured. Unpacking IMPORTANT: The scanner is shipped with two (2) security screws blocking the elevation movement. -
Page 4: Accessories
➢ 1 USB Data stick ➢ * These items may not be present, depending on the model of the scanner. Cables + Calibration set Box: 1 Imetric white box containing: ➢ 1 Calibration Plate • 1 Calibration Plate Support •... -
Page 5: Connections
Connections The scanner has 1 VGA, 3 USB and 1 Power connector (See illustration below) It is important to follow the conventions to assure that your scanner will work correctly. You will have to plug in the various cables on your computer in the correct positions. The cable of the main monitor has a Display-port plug which can't be mistaken with the one of the scanner which is a DVI plug. -
Page 6: Display Configuration
Display configuration Plug the DVI-VGA scanner cable and configure NVidia for DualView. You may need to restart your computer, after you have plugged the DVI-VGA cable, to make the Dualview option visible Start the graphic card setup panel • (i.e. NVidia Control Panel) by right clicking desktop selecting «NVIDIA Control Panel»... -
Page 7: Scanner Projector Adjustment
Scanner Projector Adjustment This procedure explains how to configure the projector. This should be made one time after • installation. It may be necessary to do this procedure after a long pause (several weeks) or if the scanning results shows “strange” behavior. Before starting the configuration, make sure the projector is on, connected and that the computer is •... - Page 8 Setup Menu For this action, the PC should be on, connected to the projector and properly adjusted. Press the “Menu” button (2) • Press ▼(5) twice to go to the «Setup» Menu • Press ►(6) to enter the menu • Press ▼(5) to select «PC»...