Advertisement
Advertisement
Table of Contents
Summary of Contents for T3 Simulations Hemmet
- Page 1 HEMMET Photo Instructions...
- Page 2 HEMMET instructions: These are resin and metal bit kits. They require some cleaning before assembly • Remove pieces from the sprues and clean all pieces • You will need super glue to assemble these kits...
- Page 3 Glue on mirrors to Add transmission block Attach upright to cab and then attach and attach to main back of engine Parts for main HEMMET body After cleaning cab to main body body and assembly glue on assembly undercarriage box wheels.
- Page 4 Flatbed and Gun Truck Version Flatbed and Gun Truck share many of the same pieces and assembly is the same for both. Attach flaps to under Attach control Attach supports to base of carriage of flatbed/gun box to base of crane truck.
- Page 5 Finished Gun Truck should look like this Use flatbed instructions for Add .50 cal bed assembly support poles and guns...
- Page 6 HEMMET Fueler version Attach box behind engine Parts for Fuel Attach flaps compartment truck. Finished Fuel Truck should look like this Attach fuel back to main truck...
- Page 7 HEMMET Wrecker Attach Attach work area to base HEMMET control box Attach flaps Wrecker parts and base to rear bed to rear bed HEMMET Attach jacks to Attach rear deck to Attach crane Attach jacks Attach Tow bar base HEMMET...
- Page 8 Attach safety lights to rear deck and tow bar support Attach tow bar assembly Finished Wrecker should look like this...
Need help?
Do you have a question about the Hemmet and is the answer not in the manual?
Questions and answers