Advertisement
Quick Links
TM Series Waterfall Pumps
Thank you for purchasing the TM series waterfall pump. This instruction manual
explains the product operations and gives important precautions regarding its safe
use. In order to use the product to maximum benefi t, be sure to read the instructions
thoroughly and follow them carefully.
To avoid accident, do not use the pump in any way other than as described in this
instruction manual especially when you see "WARNING". After reading this instruction
manual, keep it nearby as a reference in case questions arise during use.
If this instruction manual should become lost or damaged, ask your nearest dealer or
representative for another copy.
Safety & Electrical Connections
WARNING: Verify that the voltage and frequency of the electric pump shown
on the nameplate correspond to those available on the mains.
The installer must make sure that the electric system is grounded in accordance with
local ordinances.
The plug and connections should be protected from water/rain. Before using the
pump, always inspect it visually (especially power cable and plug).
Do not use the pump if it is damaged.
If the pump is damaged, have it inspected by a qualifi ed service center only.
Make sure that electric connections are protected from all water and moisture. Protect
the plug and the power cable from heat, oil or sharp edges.
WARNING: The power cable must be replaced by qualifi ed personnel only.
Grounding: The plug of the power cable has a double grounding contact, so that grounding can be performed by simply
inserting the plug.
Overload Protection: EasyPro pumps have a built in thermal protection switch. The pump stops if an overload condition
occurs. The motor restarts automatically after it has cooled down.
Prior to Operation
Check the following points upon receipt of your pump:
Is the pump exactly what you ordered? Check nameplate. Has any damage occurred during shipment? Are any bolts
or nuts loose? Have all necessary accessories been supplied? We recommend that you keep a spare pump on hand in
case of emergencies. Keep this instruction manual in a place for future reference.
TM9500 • TM13500
High Quality
Instructions for Operation • Safety • Warranty
Advertisement
Related Manuals for EasyPro TM Series
Summary of Contents for EasyPro TM Series
- Page 1 Grounding: The plug of the power cable has a double grounding contact, so that grounding can be performed by simply inserting the plug. Overload Protection: EasyPro pumps have a built in thermal protection switch. The pump stops if an overload condition occurs. The motor restarts automatically after it has cooled down.
- Page 2 Voltage of power supply must match the voltage of the pump. WARNING: Must be vented in accordance with local plumbing codes. EasyPro pumps are not designed for and CANNOT be installed in locations classifi ed as hazardous.
- Page 3 WARNING: The following may cause severe damage to pump and will void warranty: • Using an extension cord • Cutting off the ground pin or using an adapter fi tting • Working on pump or switch while plugged in • Removing motor housing, unscrewing impeller or otherwise removing impeller seal •...
- Page 4 These are not warranty items. Please take the time to verify your problem is actually a defective pump before returning. EasyPro will pay postage to return pump to you provided it is a warranty issue. If you send a pump in for warranty and it checks out fi ne — you will also be responsible for the cost of return postage.