Page 1
#8 x 3/4 Screw Vectran Line D Shackle Phil Pan Head #8 -32x3/4 Screw Cable Clamp 8/32 Nylon Insert Nut Phil Pan Head Rudder Bracket Hex Cap1/4 - 20x5/8 1/4 Lock Washer www.malibukayaks.com info@malibukayaks.com 1-877-952-9257 Malibu Kayaks LLC. all rights reserved.
Page 2
Once rope A have the appropriate square knots formed. the exit holes, and rope A should length, use lighter to burn the end sticking out. Cut rope A if it is too of the rope. long. www.malibukayaks.com info@malibukayaks.com 1-877-952-9257 Malibu Kayaks LLC. all rights reserved.
Page 3
. space between the rudder blade stopper side of the tracks. and the handle. Plus, the blade should exceed the V-Block by 1” . www.malibukayaks.com info@malibukayaks.com 1-877-952-9257 Malibu Kayaks LLC. all rights reserved.
Page 4
Make sure to use drill bit size 3/32 Use the same drill bit size as step asseembly as indicated using the or 2.3813mm. D shackles. (see instruction, “How to Tie Square Knots” .) www.malibukayaks.com info@malibukayaks.com 1-877-952-9257 Malibu Kayaks LLC. all rights reserved.
Page 5
Position the cable clamps. Make sure the vertran lines are aligned with the gunnal and away from obstacles inside of the kayak. Once the desired positions are located, drill the pilot holes and put the screws through. www.malibukayaks.com info@malibukayaks.com 1-877-952-9257 Malibu Kayaks LLC. all rights reserved.
Page 6
Tie the square knots (see instruc- tions, “How to Tie Square Knots”). Now, you’re ready to use the rudder kit. www.malibukayaks.com info@malibukayaks.com 1-877-952-9257 Malibu Kayaks LLC. all rights reserved.