Log Assembly - USSC 2020L Owner's Operation And Installation Manual

LOG ASSEMBLY

LOG POSITIONING
This unit is supplied with a set of four ceramic fiber logs. Do not handle these logs with your
bare hands! Always wear gloves to prevent skin irritation from ceramic fibers. After handling
logs, wash your hands gently with soap and water to remove any traces of fibers.
PROPER INSTALLATION SEQUENCE:
1. Install the rear log (#2) on the rear set of locators. Visually check to verify the log is securely
placed on the locators.
2. Install the front log (#1) on the front locators. Visually check to verify the log is securely
placed on the locators.
3. Place the cross logs on the locator studs in the log as shown. The flame should not touch
the cross logs otherwise suiting will occur.
#2
The positioning of the logs is critical to the safe and clean
operation of this heater. Sooting and other problems may result if
the logs are not properly and firmly situated in the appliance.
Never add additional logs or embellishments such as pine cones,
vermiculite or rock wool to the heater.
14
WARNING: Failure to position the
parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
#1
FIGURE 8 - Log Set Assembly