Advertisement
6.3.7.
Remove complete strut carefully from the spring compressor.
6.3.8.
When re-fitting the strut to the vehicle, the locking plate nut will need to be fully tightened using a torque wrench, to a setting in
accordance with the vehicle manufacturer's specification.
7. MAINTENANCE
7.1.
Before each use, check the spring compressor to ensure it is not damaged or worn. If in any doubt DO NOT use the
spring compressor. Remove it from service immediately and contact your local Sealey stockist for advice and/or repairs.
7.2.
Periodically clean the sliding columns and wipe over using a little transmission oil.
7.3.
Any other maintenance required should be carried out by an authorised service agent.
7.4.
If the spring compressor is not being used for a considerable length of time, disconnect the air supply and discharge any air in
the cylinder by depressing the foot control lever. Drop a little Sealey air tool oil into the air inlet and cover to prevent the ingress of any
foreign matter.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
RE232.V3 Issue 3 (U) 01/05/20
Advertisement
