Summary of Contents for Flexdesk Z Series
- Page 2 Thank you for purchasing a FLEXDESK Z‐SERIES. The FLEXDESK product line is designed to enhance your work space. Please follow all assembly instructions correctly to provide optimal use. Only a qualified contractor should install the FLEXDESK Z‐SERIES. If you do not understand any of the assembly instructions, please contact your local re‐seller or visit www.joromfg.com. IMPROPER INSTALLATION CAN CAUSE DAMAGE TO YOUR EQUIPMENT AND MAY LEAD TO SERIOUS PHYSICAL INJURY. JORO Manufacturing cannot take any responsibility for damage or injury resulting from improper installation. Do not operate Z‐SERIES frame if there are any immediate obstructions below or above the work station. Doing so may cause unit malfunction or lead to serious physical injury. The supplied mounting hardware is for use on the FLEXDESK Z‐SERIES only. If you encounter any problems or insufficient hardware during installation, please contact your local re‐seller. ...
- Page 3 Z-Series Main Frame Kit Up/Dwon Switch Smart Control Box 3in Swivel Glide Motor Cables - 1m Power Cable - 2m Z-Series Modesty Kit (ONLY when applicable) 5mm Allen (Hex) Key TUBE1020 End Cap Z-Series Work Surface Kit (ONLY when applicable) Note: Parts may not be exactly as shown and not to scale Z-Series ASSY Instructions : 0.001...
- Page 4 1 Fasten modesty (when applicable) Be sure to use M6 x 8mm Socket Cap Screw Start all M6 x 8mm Socket Cap Screw prior to tightening, then tighten all screws Be sure to NOT over tighten M6 x 8mm Socket Cap Screw 2 ...
- Page 5 4 #12 x 3/4" Pan Head Wood Screw Fasten the work surface (when applicable) Be sure to use the #12 x 3/4" Pan Head Wood Screw provided (when applicable) Be sure to NOT over tighten 5 #8 x 3/4" Pan Head Wood Screw Fasten the control box and switch Be sure to use the #8 x 3/4"...
- Page 6 6 Plug in cables 7 Nylon Cable Clip 1/4'' Wire management Be sure to use the Nylon Cable Clips and #8 x 3/4" Pan Head Wood Screw provided (when applicable) #8 x 3/4" Pan Head Wood Screw Be sure to NOT over tighten Z-Series ASSY Instructions : 0.001...
- Page 7 8 ...