Related Manuals for CLEANCUT Step
Summary of Contents for CLEANCUT Step
- Page 1 CLEANCUT STEP INSTALLATION GUIDE COPYRIGHT © 2017 SAFEWAY SAFETY STEP, LLC (DBA “CleanCut”) All Rights Reserved Reproduction or Distribution of this Installation Manual is Strictly Prohibited VIDEO INSTRUCTIONS CAN BE VIEWED AT cleancutbath.com...
- Page 2 DURING INSTALLATION OR SUBSEQUENT USE OF THE CLEANCUT STEP. FAILURE TO FOLLOW THE INSTRUCTIONS IN THIS INSTALLATION MANUAL SHALL VOID ANY WARRANTY GIVEN WITH RESPECT TO THE CLEANCUT STEP. IMPORTANT REMINDER - PLEASE RETURN THE PACKET THAT INCLUDES WARRANTY REGISTRATION INFORMATION.
- Page 3 Page 3 of 9 Thank you for your interest in the CleanCut Step. This installation manual includes an overview of the CleanCut Step installation kit as well as instructions pertaining to the step-by- step instructions for CleanCut Step installation. CleanCut Step Installation Kit The CleanCut Step installation kit includes the following items: •...
- Page 4 Flip the template over and now trace the outside of the tub. Keep in mind that it may not be possible to place the CleanCut Step directly in the center of the tub due to obstructions in the tub area such as the placement of sinks, vanities or commodes and the use of shower seats may warrant moving the opening forward as well.
- Page 5 Measuring & Cutting the CleanCut Step Once you have completed cutting out a section of the tub, you can begin to fit the CleanCut Step into the tub opening. The first step is to determine which size CleanCut Step you will need to complete the installation.
- Page 6 Step. Place the top of the paper template approximately ½” from the top of the CleanCut Step (Figure 3). Place the tracing on the step so the slope is similar to that of the tub. Trace the outline of the paper onto the CleanCut Step with a continuous line.
- Page 7 Page 7 of 9 Use a tape measure and transfer the shape of the inside of the tub edge to the step. The inside of the tub may be irregular in shape, so measurements for the inside line must be made every 3” from one end of the CleanCut Step to the other.
- Page 8 Insert the small box in the channel. At this point, do not adhere the small support box to anything. Place the large support box into the channel and over the top of the small box. Place the CleanCut Step into position and compress the CleanCut Step downward to determine the proper height and placement for the support box structure.
-
Page 9: Completing The Installation
Apply adhesive to the top of the large support box. It is recommended that an extra bead of adhesive be placed on the ends of the large support box as the Step curves up toward the ends. Place a substantial bead of adhesive on the top left and right side of the tub where the CleanCut Step will be seated.
Need help?
Do you have a question about the Step and is the answer not in the manual?
Questions and answers