---------------------------------------------------------------First Fold Line------Seal with tape------Do not staple-------------------------------------------------------------
Page 1
The model and serial numbers are stamped on the nameplate located next to the machine’s controls. Please print clearly. -------------------------------------------------------------------------------Second Fold Line--------------------------------------------------------------------------- Place stamp here AyrKing Corporation 2013 Cobalt Drive Louisville, KY 40299-2417 ---------------------------------------------------------------First Fold Line------Seal with tape------Do not staple------------------------------------------------------------- Store Name: Store I.D.#:...
Page 3
Read this manual thoroughly before operating machine. The model and serial numbers are on the data plate mounted on the machine. Record the model and serial numbers below. Refer to these numbers in any correspondence with AyrKing Corporation. Model _______________________________________________________________ Serial Number _______________________________________________________ Note: All procedures listed on these pages are general use guidelines.
IMPORTANT SAFETY INSTRUCTIONS Read all instructions before operating. When using electrical appliances, basic safety precautions must be followed. Use this appliance only for its intended use as described in this manual. Verify that appliance is properly installed and electrically grounded by a qualified technician in accordance with local electrical codes.
INITIAL SETUP 1. Plug in unit. 2. The marinator comes pre-set from the factory for the tumble cycle time. If this time needs to be adjusted, the access panel in front of the timer can be removed. The timer is located to the right of the start and stop switches.
MAINTENANCE 1. At the end of the day, remove the drum for cleaning. Wash thoroughly in a sink with soap and water. Make sure the gasket is cleaned. After the parts have dried, put the machine back together. 2. Check the gasket each month, replace if damaged. 3.
(if required by AyrKing) or if the failure is determined not to be covered under this warranty, AyrKing will invoice the end user for the replacement component, shipping costs, and labor charges if applicable.
Need help?
Do you have a question about the M-101Y-CP and is the answer not in the manual?
Questions and answers