Page 1
OPERATING INSTRUCTIONS MELF8247W - Larder Fridge PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USE WHEN USING ANY ELECTRICAL APPLIANCE, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED Distributed by Marks Electrical ltd IMPORTANT – If the mains lead of this appliance becomes damaged then it must be King Richards Road, Leicester, LE3 5QG replaced by the manufacturer’s service agent, or a suitably qualified person using the same...
Page 2
Getting to know your fridge Specification DO NOT TURN ON THE REFRIGERATOR FOR 2 HOURS After the refrigerator is in place it needs to be left for 2 hours, to allow the coolant fluid time to settle. Temperature control Wire shelves Salad/vegetable crisper Balcony shelves Bottle rack...
Page 3
This appliance is not intended for use by persons including children with reduced physical, This appliance can be used by children aged from 8 years and above and persons with sensory, or mental capabilities, or lack of experience and knowledge, unless they have been reduced physical, sensory or mental capabilities or lack of experience and knowledge if they given supervision or instruction concerning use of the appliance by a person responsible for have been given supervision or instruction concerning use of the appliance in a safe way...
Page 4
Avoid locating your refrigerator near a heat source, e.g. cooker, boiler or radiator. Also Adjusting the temperature avoid direct sunlight in sun lounges or conservatories. If you are placing your refrigerator in an out-building such as a garage or annex ensure that the refrigerator is placed above the The internal temperature of your refrigerator is controlled by the Temperature Control.
Page 5
Replacing the Light Bulb 1. Unplug the fridge. 2. Remove the lampshade. 3. Remove the bulb and replace. 4. Replace the lampshade. 5. Plug the fridge back in. Troubleshooting 1) The refrigerator is not working Check it is plugged in and switched on. Check that the fuse in the plug has not blown.
Need help?
Do you have a question about the MELF8247W and is the answer not in the manual?
Questions and answers