Page 1
Pepper Highchair IMPORTANT! KEEP FOR FUTURE REFERENCE INSTRUCTIONS: This product conforms to BS EN 14988-1:2006+A1:2012 Suitable for children who can sit up unaided, aged approximately 6 months but not exceeding 18kg/40lbs. Your child’s safety may be affected if you do not follow these...
Safety instructions We know that safety is of utmost concern for parents and carers of children. Whilst this product has been developed to all of the relevant safety standards, we need your help to maintain that level of safety and minimise the risk of a baby using this product being harmed.
Welcome Thank you for purchasing the MyChild Pepper Highchair. Please read the instructions and warnings carefully before use to ensure safe and satisfactory operation of this product. Your child’s safety is your responsibility. If you have a query with this product or require replacement parts, please contact the MyChild Helpline on 0161 335 2508.
Page 4
Assembling the seat unit backrest 1. Open the seat unit. 2. Ensure the backrest tubing (A) is at the back of the highchair. If it is not, then, feed the backrest tubing (A) all the way under the front bar (B) and out so that it is at the back of the highchair.
Page 5
Assembling the seat unit backrest (continued) 3. Pull the backrest seat cover from under the front bar (C) as shown. 4. Press the release latches on both sides (D) and at the same time fold the seat together. IMPORTANT! The seat must be folded together for the following two steps.
Page 6
Assembling the seat unit backrest (continued) 5. With the seat folded, feed the backrest tubing (E) into the pocket on the backrest cover, ensuring the two shoulder straps (F) are not twisted around one another. 6. Place the two ends of the backrest frame (G) onto the two ends of the seat base frame (H) ensuring both spring pins click into place.
Page 7
Attaching the tray 1. Slot the two plastic spacers (A) over the 2. With the tray turned upside down place two plastic parts on the tray frame. the tray frame (complete with spacers) onto the tray as shown. Secure the tray to the tray frame using four screws.
Attaching the tray (continued) 5. Push the tray down onto the front bar ensuring it clicks into place and secure the tray using press stud and strap (E). click click Attaching the footrest 1. Attach the footrest (A) to the footrest bar (B) using four screws IMPORTANT: DO NOT overtighten the screws.
Attaching the legs Keep fingers clear of all potential pinch points during assembly. click click 1. Attach the feet to the front and rear 2. Place the seat unit upside down on the leg tubing, ensuring the straight edge floor. (A) on each foot goes against the floor.
Page 10
Unfolding the highchair click click click 1. Holding the back of the seat frame (A) 2. Push the tray down onto the front bar and the front bar (B), open the seat unit ensuring it clicks into place and secure out, ensuring it clicks into place.
Page 11
Placing your child in the highchair (continued) The highchair should only be used with the feeding tray in place. It is essential that the five-point harness is used at all times. When using the highchair at a table ensure the child cannot push against the table or any other surface as this could result in the highchair tipping over.
Page 12
Folding the highchair (continued) 2. Standing behind the highchair press the release latches on both sides (C) and at the same time, pull the front legs towards you folding the highchair. Dismantling for travel 1. Removing the main tray: 2. Removing the legs: Press in the spring pins (A) on the Press in the spring pins (B) on the inside underside of the tray frame and at the...
Removing the harness The 5-point harness can be removed for washing or replacing. The harness should be washed by hand at 30ºC using a mild detergent. Do NOT tumble dry. Air dry only. 1. Unfasten the tray strap (A) and seat 2.
Page 14
Removing the harness (continued) 4. Standing behind the highchair press the release latches on both sides (C) and at the same time, pull the front legs towards you folding the highchair. 5. Slide the top of the seat fabric off the seatback (D) to expose the shoulder strap fixing points and unscrew screws (4 &...
Care and maintenance The highchair can be cleaned by using a sponge with warm water and a mild • detergent. The 5-point harness can be removed and hand washed at 30ºC using a mild • detergent. Do NOT tumble dry. Air dry only. See pages 10-12 for removing the harness.
Need help?
Do you have a question about the Pepper and is the answer not in the manual?
Questions and answers