Advertisement
Instruction manual
• The heater must not be located immediately
below a socket-outlet.
• Do not use this heater if it has been dropped.
• Do not use if there are visible signs of
damage to the heater.
• Use this heater on a horizontal and stable
surface, or fix it to the wall, as applicable.
• WARNING: Do not use this heater in small
rooms when they are occupied by persons
not capable of leaving the room on their own,
unless constant supervision is provided.
• WARNING: To reduce the risk of fire, keep
textiles, curtain, or any other flammable
material a minimum distance of 1m from the
air outlet.
• The heater needs to be installed so that the
switches and other controls cannot be
touched by a person in the bath or shower.
INSTALLATION
Foot asstmbly
•
Before using the heater, the feet must be fitted to the unit. (image
1)
•
These are to be attached to the base of the heater using the 8
ST12x4mm screws provided. (image 2)
4
•
Take care to ensure that the feet are located correctly on the
bottom end of the heater.
•
The heater should stand vertically once the feet are installed
(image 3). If the heater tilts backwards (image 4) then please
remove the feet and rotate them before fitting again.
Wall mounting
•
Please note that the product must be installed at least 15 cm from
the floor and 50 cm from the ceiling.
•
First install the bracket with the provided screws. (image 1)
•
Drill the holes in the wall on each side, then insert the plastic
expanded plugs and fix the bracket in the wall with the screws
provided. (image 2)
•
Place the heater in a suitable position and ensure that the holes
are aligned with the bracket. (image 3)
•
Tighten the screws on top of the bracket. (image 4)
Advertisement
