Table of Contents
Advertisement
Troubleshooting Guide
If the Unit does not perform properly when operated as instructed in this Owner's Manual, refer to the following.
Problem
No Power.
No Sound or Picture.
Distorted Picture.
Completely Distorted Picture or
Black / White Picture with DVD.
No Sound or Distorted Sound.
No DTS Audio is Output.
Picture Freezes Momentarily during
Playback.
Disc Cannot be Played back.
No Return to Start-up Screen when
Disc is Removed.
The Unit does not Respond to
the Remote Control.
Buttons Do Not Work or the Unit Stops
Responding.
The Unit Does Not Respond to some
Operating Commands during Playback.
The Unit Cannot Read CD / DVD.
Angle Does Not Switch.
The Password for Rating Level
has been Forgotten.
• Some Functions are not available in Specific modes, but this is Not a Malfunction. Read the description in this Owner's
Manual for more details on Correct Operation's.
• Not all Functions are available for all Commercial discs.
Specifications
Output Signal Format:
NTSC color
Power Source:
120 V AC + / - 10%, 60 Hz + / - 0.5%
Power Consumption:
7 W (standby : 0.9 W)
EN
INFORMATION
Corrective action
– Check if the AC Power cord is properly connected.
– Unplug from the AC outlet, and wait for 5-10 seconds and then Plug it in again.
– Check if the TV is switched On.
– Check the Video Connection.
– Check the Audio / Video Cable connections to the TV.
(Refer to page 8.)
– Sometimes a small amount of Picture Distortion may appear.
This is Not a Malfunction.
– Connect the unit directly to the TV.
– Connect this unit directly to the TV.
– Make sure the Disc is Compatible with the unit.
– Adjust the Volume.
– Check that the Speakers are Connected correctly.
– This unit does Not support DTS Audio.
This is Not a Malfunction.
– You need to set this unit to "Bitstream" in "Audio Out" Menu and also need to connect to the TV
or Amplifier that supports DTS, then the Audio will be output as DTS. It is only available when
connected via a Coaxial cable.
– Check the Disc for Fingerprints / Dirty and Clean with a Soft cloth wiping from center to edge.
– Clean the Disc.
– Ensure the Disc is inserted in Correct position.
– Insert a Correct Type disc that Plays back on this unit.
– Check if the Disc is defective by trying another disc.
– Check if the Parental settings exceeds the levels you set in the "Movie Rating" setting. (for DVD only)
– Handle a Disc with special care so that it does not have Fingerprints, Scratches, or Dust on its surface.
– Turn Off the unit once and then restart.
– Aim the Remote Control Directly at the Sensor on the Front Panel.
– Reduce the Distance to the unit.
– Re-insert the Batteries with their Polarities (+ / – signs) as indicated.
– Replace the Batteries in the Remote Control.
– Press and Hold any buttons on the Remote Control toward a Digital Camera. The Remote Control is
working if you confirm a pulsating infrared light through the Digital Camera.
– Please attempt to Reset the unit by Unplugging the AC Power cord from the Wall outlet and then
Plug it in again after 5-10 seconds.
– Operations may Not be permitted by the Disc. Refer to the instructions for the disc.
– Use a commonly available Cleaning CD / DVD disc to Clean the Lens before sending the Unit for
Repair.
– The Angle cannot be switched for a DVD which does not contain Multiple Angles. In some cases
Multiple Angles are only recorded for specific Scenes.
– Enter the Default Password "4737", then your Forgotten Password will be Cleared. Then the Rating
Level plus Password will have to be set again.
Operating Temperature:
41°F (5 °C) to 104 °F (40 °C)
Dimensions:
W
: 9.9 inches (250 mm)
H
: 2.0 inches (50.2 mm)
D
: 7.4 inches (187.7 mm)
Weight:
Approx 1.95 lbs. (0.88 kg)
– 22 –
• Designs and Specifications are subject
to change without notice.
• If there is a Discrepancy between
Languages, the default Language will
be English.
Advertisement
Table of Contents
