Advertisement
● COMFORT FOR YOUR CHILD ●
Assembly and disassembly of the wheels
Before assembly and disassembly, the detent spring must be pressed.
Seat cover
The cover can be completely removed from the seat unit to wash him.
Caution: When mounting the reference is not to forget to pull the straps through the
respective gaps.
Height adjustable and foldable slide
Press the adjuster knobs and move the slider to the desired position.
Apply the parking brake
The brake is activated by depressing the brake long wing.
When it comes to minor problems when you press the brake, push the baby pram back
and forth a little. Make sure that the brake is engaged. The brake is released again by
stepping down the wing.
Important: The manufacturer is recommended to occasionally spray the brake cable
with a silicone spray.
Application of the folding
Insert the male parts of the top joints in the corresponding, appropriate places on the
tubes.
Caution: Fix getting the push buttons on the rear side of the backrest (Drop-out protec-
tion). To provide assembly / disassembly of the hood / take the screw purely / out along
with the spring as it is stated on the image („Mounting the hood").
Important: Please do not screw together too!
Important: When adjusting the roof should be supported with the other hand the
center bracket.
Backrest adjustment
To raise the backrest, pull the free end of the strap. To tilt the brake.
Adjustable footrest
To get the lying position, raise the foot rest up and press the bracket.
Application of the 5-point belt
To release the belt, press the two lock. Put you into the child and give them his hands
through the corresponding loops. Now close the strap through the locks stuck together.
The belt can be changed by the adjuster will.
Caution: Always use the crotch together with the waist belt. Otherwise there is only
diminished safety for the child.
Guard
Insert the small parts of the safety bar into the holes on the seat
Caution: Make sure that the guard snaps on both sides. To remove, press the release
buttons on the insert parts. In order to facilitate the entry and exit of your child, it is
sufficient to solve one side of the strap and fold up.
Roof with (concealable) mosquito net use
Installation of the hood
Important:
Correct assembly of the folding parts
(part 5).
Please not too strong bolt together!
Variation: Child car seats (group 0 +)
Brake circuit. Assembly and disassembly of the wheels
Adjustable backrest of the carrycot (3-position)
Handling of the 5-point belt
www.wampol.eu
www.babynana.eu
Adjustment of the backrest
Advertisement
