Advertisement
System connection ow diagram
Installation of Reciever
• Keep the machine 1m above the ground
• Keep the machine away 1m against the wall.
• Fully pull the antenna up
• Make the transmitter point to the antenna without barrier
• Keep the reciever away any digital equipment (such as CD, VCD, PC, or other
radio equipment)
TROUBLESHOOTING
Some problems and their solutions are identi ed in the table below. If you are
unable to solve a problem, contact your dealer.
Problem
No sound; RF light(s)
• Make sure the transmitter is ON
not glowing
• POWER switch is ON and the receiver is piugged
into a power source. Check battery.
• Check receiver squelch setting.
• Check receiver antenna connection(s}.
• Make sure antennas are in line of sight of
transmitter.
No sound;
• Turn up receiver audio VOLUME control
RF lights glowing.
• Check for proper connection between receiver
and karaoke unit
6
www.PyleUSA.com
Solution
Problem
Received signal is noisy.
• Check the battery
Contains extraneous
• Remove local Sources of RF interference.
sounds. Theres sound
• If using a guitar or other instrument, check
while transmitter is ON.
connections.
• Two transmitters may be operating on the same
frequency. Locate and turn one o .
• Signal may be too weak. Reposition antennas.
lf possible, move them closer to the transmitter.
• Adjust receiver squelch control.
Noise from receiver
• Remove localsources of RF interference.
while transmitter is o .
• Reposition receiver or antennas.
Momentary loss of sound
Reposition receiver and perform another
as transmitter is moved
"walk through" test and observe the RF indicators.
around performing area.
If audio drop outs persist, mark these "dead spots"
in performing area and avoid them during
performance.
Solution
7
www.PyleUSA.com
Advertisement
