Storagewerkz Mywerkz 46000 Instruction Manual

Instruction Manual
Thank you for purchasing a storagewerkz™ Garage Storage System. If you have any questions or require support during this time, please contact
our customer service department at info@mywerkz.com.
46000 – with a weight capacity up to 60 lbs.
Warning!
Before installing your new storagewerkz™ Garage Storage System, please read and fully understand the instructions and warnings contained in this
manual. Failure to follow these instructions completely can result in serious bodily injury, damage to the equipment or voiding of the warranty. The
installer is responsible for following these instructions to ensure that all components are installed correctly.
• Installations should be performed by someone with proper mechanical skills and experience in basic assembly.
• The surface where the unit is to be installed should be inspected to verify the weight of the equipment being installed can be supported.
• Not following these guidelines can result in damage to not only the mounting surface, but the unit and equipment as well. If necessary, reinforce
the mounting surface to properly accommodate the installed equipment.
• It is the responsibility of the installer to make sure the installed equipment does not exceed the maximum weight indicated for this unit.
• Always inspect the area behind the mounting surface. Make sure it is free of gas, water or waste lines and electrical cables and wires.
• Make sure to tighten all screws properly, but do not overtighten. Overtightening can greatly reduce the screw's ability to securely support the unit
and the attached equipment.
Please read these instructions carefully before using.
Load capacity : 60 Lbs.
MODEL: 46000