Download Print this page

MYODYNAMIK EQUINE CURO Mk 0 User Manual

CURO Mk 0

Table of Contents

Need help?

Do you have a question about the EQUINE CURO Mk 0 and is the answer not in the manual?

Page 1 CURO Mk 0...
Page 2 CURO: Getting started - Turn on your CURO acoustic myography unit by pressing the ON/OFF button (olive green circle) for approximately 1 second. If the LED lights a steady green, then the battery capacity is more than If the LED light flashes red, then the battery capacity is approximately 30--‐50% If the LED light is red, then you should charge the unit before use.
Page 3 CURO: Stopping - To stop a recording, you should press the button for more than 2 seconds. The red LED will go out. - To turn off the wireless WiFi data transmission, you should press the WiFi button for more than 2 seconds. The green LED will go out. -...
Page 4 - When the Power Adaptor is connected, the CURO unit automatically enters “charging” mode, and immediately starts charging. The ON/OFF button will light up green and start flashing to indicate that charging is in progress. Once the ON/OFF LED stops flashing and shows a steady green, then the battery is fully charged and your CURO is ready to start recording once again.
Page 5 Product “CURO” units for research purposes. - The MyoDynamik ApS product “CURO” and acoustic myography sensor is provided to you on an “AS IS” basis having been tested in the factory prior to distribution. You are welcome to write with regard to technical support (myodynamik@myodynamik.com) remembering to identify the serial number of the CURO and clearly...