LAWNFLITE LS83000EV Operator's Manual

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Log Splitter

LS83000EV

Operator's Manual

Before operating this appliance, please ensure that you read &

understand all the instructions that apply to it, as failure to comply with

these instructions may result in personal injury, injury to other persons,

and also increase the risk of fire. Please ensure that any replacement

parts or accessories used with this appliance are correctly and/or

securely fitted before use.

Please retain these instructions for constant reference.

Made For E.P.Barrus OX26 4UR

Version 01: 2019

Table of Contents

Need help?

Do you have a question about the LS83000EV and is the answer not in the manual?

Questions and answers

Summary of Contents for LAWNFLITE LS83000EV

Page 1 Log Splitter LS83000EV Operator's Manual Before operating this appliance, please ensure that you read & understand all the instructions that apply to it, as failure to comply with these instructions may result in personal injury, injury to other persons, and also increase the risk of fire. Please ensure that any replacement parts or accessories used with this appliance are correctly and/or securely fitted before use.
Page 2: Table Of Contents
INTRODUCTION TABLE OF CONTENTS Introduction Your new log splitter will more than s a t i s f y y o u r e x p e c t a t i o n s . I t h a s Symbols been manufactured under stringent Safety...
Page 3: Symbols
SYMBOLS SAFETY Safety Warnings & Instructions The rating plate on your machine may show symbols. These represent i m p o r t a n t i n f o r m a t i o n a b o u t t h e UNDERSTAND YOUR LOG SPLITTER product or instructions on its use.
Page 4 DRESS PROPERLY PREVENT FIRES Do not smoke or have open flames Do not wear loose clothing, gloves, when operating or refilling the log neckties or jewelry (rings, wrist watches). splitter. Never operate the log splitter They can be caught in moving parts. near a flame or spark.
Page 5 AVOID INJURY FROM UNEXPECTED ACCIDENT NEVER LEAVE TOOL RUNNING UNATTENDED Do not straddle or reach across the Don't leave tool until it has come to a splitting area when operating the log complete stop. splitter. Never pile logs to be split in DISCONNECT POWER a manner that will cause you to reach across the log splitter.
Page 6: Special Warnings & Instructions
Specifications LS83000EV Model Number (230V ~ 50Hz 13A) Motor 3000W S6 40% 8-30 cm Dia.
Page 7: Unpacking
APPLICATION CONDITIONS For model #65887, #65887(A): With 230 Volt / 50Hz motor, the log splitter This log splitter is designed for operating should be connected to standard 230V±10% under ambient temperatures between +5°C /50Hz±1%. and 40°C and for installation at altitudes no more than 1000m above M.S.L.
Page 8: Contents Supplied
CONTENTS SUPPLIED 1. Log Splitter Frame 7. Operator's Manual 2. Control Lever and Guard Assy (1 pair) 8. Hardware Bag, including 3. Adjustable Log Holder (1 pair) 4. Retainer 1 and Retainer 2 5. Wheels (1 pair) × 2 × 2 6.
Page 9: Assembly
Support Table ASSEMBLY 1. Before assembly, loosen the star Wheels knob by turning it counterclockwise. 1. Pass the axle through the wheel from outside and put on two washers as shown in the following figure. Slide the axle into the two holes on the base of log splitter and secure it with another washer and R-pin from inside.
Page 10 Control Lever Adjustable Log Holder Pull Spring Pin (A) to remove the Lock Align the holes and assemble the retainer 1 and retainer 2 onto the clamps. Ensure Pin (B). Apply a thin coat of grease to both surfaces of the Control Lever the direction of the retainers as shown Guard as illustrated.
Page 11: Know Your Machine
KNOW YOUR MACHINE Transport Handle Split Wedge Log Holder Adjusting Knob Adjustable Log Holder Motor Support Table Oil Tank Cover / Air Bleeder Wheels Ram Travel Adjusting Rod Control Lever Control Lever Guard Control Levers Connection Bracket Plug & switch Base Base Cover...
Page 12: Transport
TRANSPORT If using a crane, lay hoist sling at the lifting point (A). The log splitter is equipped with 2 wheels for minor moving. To move the log splitter to the work site. Grip the For long distance transport, handle (A) to tilt the log splitter slightly fasten the log splitter at the after making sure the oil tank cover is position with bundling sign...
Page 13 6. While operating under extremely low temperature, keep the log splitter running under no load for 15 minutes to preheat the hydraulic oil. 7. Before initial operation, check to be sure the two-handed operation is properly functioning by following steps: (1) Lower both control levers, the splitting wedge will lower to 5cm above the highest table position.
Page 14 11. Hold the log with clamping brackets 9. Place log onto splitter. Place the log closely in the control lever guards. onto the support table vertically and lower levers to start the splitting. sitting flat on the support table. Be Releasing either lever stops the sure the wedge and support table motion...
Page 15: Replacing Hydraulic Oil
Use a drain pan to aid in the removal of REPLACING all used oil and particles. HYDRAULIC OIL Remove oil drain plug to drain oil from hydraulic transmission system. Examine oil for metal chips as a The hydraulic system is a closed system precaution to future problems.
Page 16: Sharpening Wedge
Read dipstick to determine SHARPENING WEDGE the maximum and minimum of the oil level. Low oil This log splitter is equipped with a can damage the oil pump. reinforced splitting wedge and has a Overfilling can result in blade which is specially treated. After excessive temperature in long periods of operation, and when the hydraulic transmission...
Page 17: Wiring Diagram
WIRING DIAGRAM HYDRAULIC SYSTEM DIAGRAM...
Page 18: Parts Schematic
PARTS SCHEMATIC...
Page 19 Parts List Description Q'ty Description Q'ty Side Log Support 2 37 Screw M6x8 Side Log Support 1 38 Locknut M4 Locknut M8 39 Switch Washer 8 40 Screw M4x60 Spring Motor Bush 42 Screw M6x10 Bolt 8.8 M8x210 43 Washer 16 44 Pull Rod G5 Log Support C1 Bolt 8.8 M8x60...
Page 20 Description Q'ty Description Q'ty 73 Bolt 8.8 M8x45 Clip 3 74 Oil Plug A6 82 Washer Groupware 16 75 Oil Hose C1 83 Bolt M16x25 76 Oil Hose 13 84 Wheel 77 Screw M8x35 85 Wheel Axle C1 78 Shield C1 86 Wheel Cap 79 Big Washer 6 87 Long Shaft A4...
Page 21 - Machinery Directive: 2006/42/EC - EMC Directive: 2014/30/EU E P Barrus Ltd hereby declares that the product: Machine type: 8T Log Splitter Machine model: LS83000EV Mass in kg: 110Kg Rated Power: 3000W S6 40% Cutting Capacity: 550mm Conforms to the main safety requirements of the EC Directives listed above.