Page 2
For to the device. Depending of the resistance in the information on how to connect other kind of sensors sensor, the batteries duration is different than in the to the device please contact HC Technologies. following table. Frequency of SIGFOX...
Page 3
CONF1 led (yellow) will light twice. In this case, a configuration packet will be sent (contains the internal configuration of the device). (Contact HC Technologies to receive the format and description of the packet). State 3: Magnet placed for more than 4 seconds near the mark.
Page 4
To ensure tightness it is recommended that in case of having to open and close the lid more than 2 times, please contact HC TECHNOLOGIES for the supply of spare sealing rubber. The configurator must be connected to a USB port of a PC, Laptop or Tablet with Windows OS installed.
5. SENSOR INSTALLATION IN HC-ANA BOX special cases in which greater power capacity is HC Technologies can install the sensors into the HC- required. ANA box if needed. We can install the sensors in...
For other types of installation, consult HC TECHNOLOGIES. The main objective is to install the device inside the manhole, but the flat antenna, outside of it:...
Page 7
HC-ANA devices installation manual For any questions or clarification about this or other products please contact HC TECHNOLOGIES through the following procedures: Email: info@hc-technologies.com +34 947500515 HC TECHNOLOGIES Office: HC TECHNOLOGIES Calle Miranda do Duro 5 1-4 09400 Aranda de Duero, Burgos (Spain)
This manual is also suitable for:
Hc-ana-sig-z1-w-bHc-ana-sig-z2-w-bHc-ana-sig-z4-w-bHc-ana-sig-z1-f-bHc-ana-sig-z2-f-bHc-ana-sig-z4-f-b...
Show all
Need help?
Do you have a question about the HC-ANA Series and is the answer not in the manual?
Questions and answers