Error Signals - ABB DWTL1 User Manual

ERROR SIGNALS

When setting up programs, in case of a discrepancy, the following
error messages can occur:
on and off events with different frequency (each
on event must have an off event)
on and off concomitant events of the same
program
Two or more consecutive on events of the same
program / Two or more consecutive off events of
the same program
Invalid date
Insufficient memory
Attempt to set an on pulse when is already
stored an off pulse (see page 25)
Attempt to set an off pulse when is already
stored an on impulse (see page 25)
Attempt to set an on holiday program when is
already stored an off holiday program (see page
25)
Attempt to set a holiday off program when a
holiday on program is already stored (see page
25)
Attempt to set a holiday program of on and off
events on different days of the week (see page
31)
Attempt to set an astro program when is already
stored a time program (see page 25)
Attempt to set a time program when is already
stored an astro program (see page 25)
Error accessing memory *
* In this case, carry out a hardware reset (see page 51).
If the error persists, contact ABB technical support mobile
- 56 -
User manual DWTL1