Page 1
IDDEN IDDEN AYBED AYBED AYBED WITH WITH WITH IDDEN IDDEN IDDEN 21011, 21031, 21051, 21061, 21071, 21121 H H H H H D D D D D ..ARDWARE ARDWARE RAWER RAWER ARDWARE ARDWARE ARDWARE AND...
Page 2
Carefully lay out all hardware and parts. Check quantities and match to Hardware Bag & Carton Parts Lists. If a part is missing or broken contact your dealer or Legacy, 812/ 883-3111, (FAX 812-883-1819), http://www.childcraftind.com, for a replacement part or instructional literature.
LH01799:01/01 Install Stretcher Y which is closest to the Stationary Side N using (2) K- 2 - D 2: A IAGRAM TTACH THE TRETCHERS TO THE D Bolt Plugs E and (2) Allenhead K-D Bolts G as shown. K-D Bolts G will &...
Page 4
LH01799:01/01 4 - D 4: I IAGRAM NSTALLATION OF ROPSIDE Engagement PREPARATION FOR INSTALLATION OF DROPSIDE: of (metal) Top Loosen the two Allenhead Bolts G (Dropside only) which Track and Upper Guide attach the Stretcher Y to the Headboard L and Footboard Bushing C C C C C will M to prepare for Dropside O installation.
Page 5
LH01799:01/01 5 - D 5: B 5B. Install Threaded Connectors K IAGRAM UILD P OF RAWER into Drawer Front S as shown. DO NOT 5A. Attach Metal Drawer Rail-Right H H to Drawer End- OVERTIGHTEN. Right Q by matching to pilot holes, affix (3) Flathead Phillips Wood Screws L L as shown.
Page 6
NO ABRASIVE CLEANERS, SCOURING PADS, STEEL WOOL, OR COARSE RAGS SHOULD BE USED TO CLEAN THIS FINE FURNITURE. •STORAGE AND USE OF YOUR LEGACY CRIB: A printed plastic pouch is attached to the crib spring for the permanent storage of the assembly directions.
Page 7
Φ Φ Φ Φ Φ BEFORE EACH USAGE OR ASSEMBLY, INSPECT CRIB FOR DAMAGED HARDWARE, LOOSE JOINTS, MISSING PARTS OR SHARP EDGES. DO NOT USE CRIB IF ANY PARTS ARE MISSING OR BROKEN. ASK YOUR DEALER OR LEGACY, P.O. BOX 444, SALEM, IN 47167-0444 USA (812/883- 3111), service@childcraftind.com FOR REPLACEMENT PARTS AND INSTRUCTIONAL LITERA- TURE IF NEEDED.