TE Connectivity 2352906 Series Quick Installation Manual

12-Port GIGABIT MANAGED RACK MNT
PoE SWITCH QUICK INSTALLATION GUIDE
INTRODUCTION
The 2352906 series is a managed 10G/2.5G redundant PoE Ethernet switch with 8x
10/100/1000 Base-T(X) P.S.E. and 4x 1G/2.5G/5G/10GBase-T ports, specifically de-
signed for the toughest environment and fully compliant with EN50155. The switch
supports Ethernet Redundancy protocols such as TE-Ring (recovery time < 30ms over
250 units), TE-Chain, MRP and MSTP (RSTP/STP compatible) which can protect your
mission critical applications from network interruptions or temporary malfunctions.
2352906 also support Power over Ethernet, a system to transmit electrical power up
to 30 watts per port, along with data, to remote devices over standard twisted-pair
cable in an Ethernet network. The series can also be managed centralized and conve-
nient by TE-Vision, Telnet and console (CLI) configuration.
PACKAGE CONTENTS
The device is shipped with the following items. If any of these items is missing or da-
maged, please contact your customer service representative for assistance.
• 2352906 series Ethernet switch
• Rack monting kit (Left + Right)
• CD Containing software
• Quick Installation Guide
PREPARATION
Before you begin installing the device, make sure you have all of the package contents
available and a PC with Microsoft Internet Explorer 6.0 or later, for using web-based
system management tools.
Safety & Warnings
Elevated Operating Ambient: If installed in a closed environment, make sure
the operating ambient temperature is compatible with the maximum
ambient temperature (Tma) specified by the manufacturer.
Reduced Air Flow: Make sure the amount of air flow required for safe operation
of the equipment is not compromised during installation.
Mechanical Loading: Make sure the mounting of the equipment is not in a
hazardous condition due to uneven mechanical loading.
Circuit Overloading: Consideration should be given to the connection of the
equipment to the supply circuit and the effect that overloading of the circuits
might have on overcurrent protection and supply wiring. Appropriate
consideration of equipment nameplate ratings should be used when addressing
this concern.
DIMENSIONS (in mm)
EN 50155
SWITCH