Troubleshooting - Blue Rhino UniFlame GTL702W Owner's Manual

Troubleshooting

Problem
Burner will not light using igniter
Sudden drop in gas flow or reduced flame height
Irregular flame pattern
Flame blow out
Flame seems to lose heat when burning in cold weather
- temperature below 50ºF
Possible Cause
Electrode and burners are wet.
Electrode cracked or broken - sparks at crack.
Wire loose or disconnected.
Wire is shorting (sparking) between igniter and electrode.
Bad igniter.
No gas flow.
Coupling nut and regulator not fully connected.
Obstruction of gas flow.
Disengagement of burner to valve.
Spider webs or insect nest in venturi.
Burner ports clogged or blocked.
Out of gas.
Burner ports are clogged or blocked.
Low on LP Gas
Excess flow valve tripped
Ice has built up on the outside of the LP gas tank because the
vaporization process is too slow.
If problems can not be corrected by using these methods, please contact 1.800.762.1142 fo assistance.
Outdoor LP Gas Light Model No. GTL702W
Prevention/Cure
Wipe dry with cloth.
Replace electrode.
Reconnect wire or replace electrode/wire assembly
Replace igniter wire/electrode assembly
Replace igniter
Check if LP gas tank is empty. If LP gas tank is not empty, refer
to "Sudden drop in gas flow (reduced flame height). If empty,
replace.
Turning the coupling nut about one-half to three quarters
additional turn until solid stop. Tighten by hand only-do not use
tools.
Clear burner tubes. Check for bent or kinked hose.
Reengage burner and valve.
Clean venturi.
Clean burner ports.
Check for gas in the LP gas tank
Clean burner ports.
Replace LP gas tank
Refer to "Sudden drop in gas flow"
Turn OFF the control knob and the LP gas tank. Replace with a
spare LP gas tank and resume burning. Store a spare LP gas
tank in a well ventilated area away from children.