Safety Instructions - Waldbeck Aquaklar User Manual

EN
18

SAFETY INSTRUCTIONS

The pressure filter with integrated UVC lamp is a closed system for the
biological and mechanical filtering of pond water with a temperature between
+4 ° and +35 ° C. It was designed exclusively for household use to clean ponds
with and without fish.
• Dangerous ultraviolet radiation. The rays of the UVC lamp are harmful to
eyes and skin. Never use the lamp outside of the housing.
• The pond pressure filter should be set up at least two metres away from
the pond to prevent it from falling in.
• The filter should be turned on in front of the UVC lamp and the lamp
should never be active without running water.
• Do not use the device if the connection cable, the UVC lamp or the housing
appears to be damaged.
• Do not use the appliance while people are in the water.
• Should overheating occur, the built-in temperature sensor will
automatically shut off the UV lamp. It will turn the device back on after the
temperature returns to normal.
• Never open the case or the lamp unless explicitly stated in this manual.
• Make sure that a fuse with max. 30 mA with a safety switch (FI or RCDI) is
installed.
• Always unplug all plugs before working on the filter.
• For your own safety, consult an electrician if you are unsure about
connecting the electrical parts.
• Never immerse the device in water.
• Never use connections, adapters, extensions or connection cables without
a fuse.
• Keep the connection parts dry.
• Never pull or carry the device by the power cord. Do not allow the power
cord to come into contact with sharp objects or heat.
• Place the cables in such a way that they do not obstruct the way and so
that they cannot be damaged.
• The water pressure in the filter must not exceed 0.2 bar.
• Only operate the filter with hoses that are designed for a pressure of at
least 0.2 bar.
• Check and clean the drain towards the pond at regular intervals.
• Always keep free of debris, otherwise there might be an increase in
pressure, which can lead to leakage and drainage of the pond.
• As long as the filter is being operated in 'filter mode' , all connections of the
hoses must be sealed with a sealing cap.
• Before turning on the filter, make sure all connections are correctly made
and that all connections are tight.
• Never filter liquids other than water.
• If it is frosty, you must remove the filter.
• Place the filter so that it is not exposed to direct sunlight.