Table of Contents
Advertisement
Notes:
•
If there is any foreign matter on the rubber seal located on
the under side of the battery cover, the handset may not
be water resistant.
•
The rubber seal should be kept clean and replaced every 2
years to ensure the handset is water resistant even if the
seal does not look worn.
•
Do not place an excessively dirty handset in the base.
•
Shake excess water from handset prior to placing back in the
charging cradle.
Installing the Belt Clip
Line up the tabs with the holes on each
side of the handset. Press the belt clip
down until both tabs click into place.
To remove the belt clip, pull both sides
of the clip to release the tabs from the
holes.
Resetting Handsets
If you want to register the handset to a different base or replace a hand-
set with another one, you must first clear the registration information
from the base and the handset.
1. Press and hold [ ] and [#]
for at least 5 seconds, until the
SYSTEM RESET menu appears.
2. Select the DEREGISTER HS submenu. WHICH HANDSET?
appears in the display.
3. Move the cursor to select the handset ID to be de-registered from
the list, and then press the OK soft key. DEREGISTER HS
appears.
4. Move the cursor to select YES, and then press the OK soft key.
When ARE YOU SURE? appears, select YES. You will hear a
confirmation tone.
8
Advertisement
Table of Contents
