Download Print this page

DIG GF100 Installation Instructions

Gravity feed drip irrigation kit

Advertisement

Quick Links

(50) 1-GPH Button Drippers
part# W221B
(4) 1/2" Compression Tees
part# C35
(1) 1/2" Compression Coupling
part# C33
(4) 1/2" Compression Elbows
part# C36
(5) Hose End Figure "8"
part# F68B
DIG CORPORATION THREE - YEAR WARRANTY
DIG CORPORATION warrants these products to be free from defects in material and workmanship for a period of
three years from date of purchase. This warranty does not cover damage resulting from accident, misuse, neglect,
modification, improper installation or subjection to line pressure in excess of 50 lbs. per square inch. This warranty shall
extend only to the original purchaser of the product for use by the purchaser. This warranty shall not cover batteries
or any malfunction of the product due to battery failure. The obligation of DIG CORPORATION under this warranty is
limited to repairing or replacing at its factory this product which shall be returned to the factory within three years after
the original purchase and which on examination is found to contain defects in material and workmanship.
DIG CORPORATION SHALL IN NO EVENT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY
KIND; THE SOLE OBLIGATION OF DIG IS LIMITED TO REPAIR OR REPLACEMENT OF DEFECTIVE PRODUCTS. SOME
STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE
ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.
Unattended use for prolonged periods without inspection to verify proper operation is beyond the intended use of this
product, and any damage resulting from such use shall not be the responsibility of DIG CORPORATION. There are no
warranties which extend beyond the description on the face hereof. In the case of purchase of the product for use other
than, for irrigation purposes, DIG CORPORATION hereby disclaims any implied warranties including any warranties of
merchantability and fitness for a particular purpose. In the case of the purchase of the product for personal, family or
household purposes, DIG CORPORATION disclaims any such warranties to the extent permitted by law. To the extent
that any such disclaimer or implied warranties shall be ineffectual, then any implied warranties shall be limited in
duration to a period of one year from the date of the original purchase for use by the purchaser. Some states do not
allow limitation on how long an implied warranty lasts, so the above limitation may not apply
to you. In order to obtain performance under this warranty, the unit must be returned to the factory, along with proof of
purchase indicating original date of purchase, shipping prepaid, addressed as follows:
DIG CORPORATION, 1210 Activity Drive, Vista, CA 92081. Repaired or replaced units will be shipped prepaid to the
name and address supplied with the unit returned under warranty. Allow four weeks for repairs and shipping time.
Repair of damaged units not otherwise within warranty may be refused or done at a reasonable cost or charge at the
option of DIG CORPORATION. This warranty gives you specific legal rights, and you may also have other rights which
vary from state to state.
1.800.322.9146 FAX: 760.727.0282
1210 Activity Drive
www.digcorp.com
Vista, CA 92081-8510
dig@digcorp.com
CONTENTS
(10) 1/2" Tubing Holder Stakes
part# R60
(10) 1/4" Barbs
part# H80A
(10) 1/4" Tees
part# H82A
(20) 1/4" Stakes
part# P33B
(10) Goof Plugs
part# G79B
Printed in the USA. We at DIG strongly believe in conservation.
Please recycle whenever possible. 082118
Thank you for purchasing the DIG's Model GF100 Gravity Feed Drip Irrigation Kit. Please take the time to
read through the enclosed instructions and follow them step by step. If you have any questions, please call
our customer service line at 1.800.344.2281.
Let your landscape thrive with a slow and precise drip watering kit that connects to a gravity feed barrel
or to an outdoor faucet. DIG's GF100 kit is a complete kit designed for a low-pressure gravity feed system
for up to 50 plants. The kit includes all the parts needed to install a drip irrigation system to water roses,
vines, shrubs or vegetables, starting from a raised rain barrel with a 3/4" hose thread outet. The kit can also
be used from a garden faucet using the included pressure regulator. Use the following guidelines to design
and install an efficient low-volume irrigation system from a rain barrel that conserves water and promotes
a healthy environmment.
AMPLE
Before you start:
The GF 100 Gravity Feed Drip Irrigation Kit contains all the parts necessary to install a drip system that
starts from a rain barrel or outdoor faucet. Select a 60- to 200-gallon rain barrel (not included) and raise
it above the ground for best results. All of the included threaded fittings are "hose" type, so no Teflon tape
is needed to seal the connections, and they should be tightened clockwise until they are only "hand tight".
The 1/2" poly tubing serves as the main supply line which starts from the faucet at the bottom of the
rain barrel.
REV A
26-035
INSTALLATION INSTRUCTIONS
Model GF100
INTRODUCTION
ABOUT YOUR GF100 KIT
L
INSTALLATION
Gravity Feed
Drip Irrigation Kit

Advertisement

loading

Summary of Contents for DIG GF100

  • Page 1 Let your landscape thrive with a slow and precise drip watering kit that connects to a gravity feed barrel or to an outdoor faucet. DIG’s GF100 kit is a complete kit designed for a low-pressure gravity feed system DIG CORPORATION THREE - YEAR WARRANTY for up to 50 plants.
  • Page 2 Barrel faucet connections: Initial system start-up Begin the installation at the rain barrel by turning the 3/4″ Y hose Turn the water on again, flush the line[s], this will flush out any dirt end splitter (optional) onto the male threads of the rain barrel faucet. or debris that may be in the line.