Configuration Guide TERRATEC Aureon 7.1 USB in Windows XP For the installation of the Aureon 7.1 USB are two steps necessary: 1. The automatic installation of a generic USB driver. 2. The control panel installation from the software CD. 1.) As soon as you connect the Aureon with your PC, Windows XP installs a generic USB driver onto your system.
Page 3
In order to use all connected Speakers, you have to make a few more settings as shown below! The “Aureon 7.1 USB” has to be set as „Default device“. If this is done, click on „Ad- vanced“ at the “Volume”-Tab to enable the 7.1 surround functionality Choose „7.1 home theatre speakers“...
Page 4
In order to use the Aureon 7.1 USB as your default record device, you have to follow the next steps shown below. (This applies to both microphone inputs). Here you have to set the Aureon 7.1 USB as default device for recording.
Page 5
Please note: To use the soundcard you have to go to step 2, without this, there is no output on the Aureon 7.1 USB. We now get to the final step, the installation of the control panel: 2.) For full functionality, please install the control panel, which you find in the start-up of...