adapt X1 Wall Track Installation Instructions Manual

X1 Wall Track
Installation Instructions

IMPORTANT WALL TRACK SAFETY NOTICE

• To use the X1 requires the installation of the provided Wall Track. *
• Do not commence installation until you have read and understood the instructions and
warnings contained in this installation sheet.
• Professional installation is highly recommended.
• Improper installation or use of the X1 or Wall Track may cause damage or serious injury.
• Be aware of electrical wiring before any drilling or screwing into walls.
• Only mount the Wall Track to a structural wall or structural stud. Examples of structural
walls include:
o Solid walls (brick, masonry) or
o Plaster walls with approved structural stud
• If mounting to timber or steel wall studs, make sure that the mounting screws are anchored
into the centre of the studs. Use of a stud finder is highly recommended.
• The wall must be flat. If the Wall Track is not installed onto a flat surface then it will be
difficult to use the X1 properly.
• Due to forces experienced by the Wall Track when the X1 is in use, each screw must be
installed firm and tight.
• Regularly check each screw is firm and tight in Wall Track. Tighten each Wall Track screw
as required.
• Do not conduct the Wall Track installation process within 5m (16ft) of others as this will
present a safety risk.
• Any personal or property damage or injury caused by a lack of personal care or not
following the instructions fully is not covered by the warranty.
• Do not place the X1 or the Wall Track in the following environments:
o An area of high humidity such as a bathroom
o Near any heat source such as stoves and other devices that produce heat
o Near kitchen counters
o An area exposed to wind or rain
o Do not install in excessively dusty places
*Professional installation is highly recommended