Summary of Contents for Casa Systems NetComm CloudMesh Satellite NS-01
- Page 1 NS-01 – USER GUIDE CloudMesh Satellite Doc No. UG01221 CloudMesh Satellite – NS-01 1 of 19 UG01221 v1.0 May 2020 © NetComm Wireless 2020...
- Page 2 Copyright Copyright© 2020 NetComm Wireless Limited. All rights reserved. NetComm Wireless Limited was acquired by Casa Systems, Inc. a Delaware company on 1 July 2019. The information contained herein is proprietary to Casa Systems, Inc. No part of this document may be translated, transcribed, reproduced, in any form, or by any means without prior written consent of Casa Systems, Inc.
-
Page 3: Table Of Contents
Contents Overview ........................4 Connect client devices ....................11 Introduction ................................. 4 Connect a client via WPS ..........................11 Prerequisites................................ 4 Connect a client via Ethernet cable ....................... 11 Notation................................4 Turn off the LED light ....................11 Package contents ......................5 NS-01 Web User Interface .................. -
Page 4: Overview
Notation Overview The following symbols may be used in this document: Introduction Note – This note contains useful information. This document provides information related to the installation, operation, and use of the Important – This is important information that may require your attention. CloudMesh Satellite. -
Page 5: Package Contents
Product features/functionality Package contents The CloudMesh Satellite package consists of: Perfect for 1 x NetComm CloudMesh Satellite (NS-01) 1 x RJ45 Ethernet cable End-users living in larger units / houses searching for a seamless whole-home network solution to improve WiFi coverage. 1 x Quick Start Guide ISPs looking to provide a cost-effective, fully integrated WiFi Mesh solution with full 1 x Warranty Card... -
Page 6: Interfaces
Interfaces Rear view Front view Figure 2 – Rear view interfaces N O . I N T E R F A C E D E S C R I P T I O N Ethernet ports Gigabit Ethernet LAN ports. Can be used to connect clients in bridge mode. -
Page 7: Bottom View
Bottom view Physical dimensions and weight The table below lists the physical dimensions and weight of the CloudMesh Satellite. D I M E N S I O N S Width 113 mm Height 145 mm Depth 110 mm Weight 320 grams Table 4 - Physical dimensions and weight Figure 3 –... -
Page 8: Cloudmesh Satellite Location
CloudMesh Satellite location Common location considerations If you have concerns about your network’s performance that might be related to range or Your CloudMesh Satellite works best when it is placed in a central location to the area you want obstruction factors, try moving the device to a position between three to five metres from the to cover. -
Page 9: Pair The Cloudmesh Satellite With Your Cloudmesh Gateway
Pair the CloudMesh Satellite with your CloudMesh Gateway Paired via WPS If the CloudMesh Satellite and the CloudMesh Gateway have not been setup by your internet service provider, you will need to pair these devices together. Preconfigured – already paired The CloudMesh Satellite can pair with a CloudMesh Gateway using the WPS (Wi-Fi Protected Setup™) functionality of each device. -
Page 10: Pair Via Ethernet Cable
Pair via Ethernet cable LED indicators An alternative pairing method to using WPS (see page 9) is to use the yellow RJ45 Ethernet cable (supplied with the satellite) connected to the Ethernet port of each device to pair the The following table explains the meaning of the different coloured LED indicator lights and CloudMesh Satellite with a CloudMesh Gateway. -
Page 11: Connect Client Devices
Connect client devices Connect a client via Ethernet cable Alternatively, you can directly connect a device, for example a printer, to the CloudMesh You can connect any number of WiFi enabled client devices to the internet via the NS-01 Satellite using an ethernet cable. CloudMesh Satellite using the WPS (WiFi Protected Setup™) functionality of each device. -
Page 12: Web User Interface
Appendix B – Set NS-01 IP connectivity to access NS-01 Web User Interface If the device is not paired, please first follow Web UI to set up a static IP for the Satellite and then continue from step 4.b of this section, below. - Page 13 Click the Browse button to locate and upload the NS-01 firmware upgrade file. At the Authorization Required screen: Figure 8 – Log in to NS-01 user interface Type admin into the Username field, Enter the serial number (Serial No) printed on the label on the label on the bottom of the NS-01 into the Password field, and Figure 10 –...
-
Page 14: View The Ns-01 Log
CloudMesh Satellite reset A progress message page appears: To reset the CloudMesh Satellite, insert a straightened paper clip or similarly shaped object into the small hole on the bottom of the satellite marked with the reset icon Figure 12 – Uploading in progress message Wait four to six minutes and then refresh the browser, you will be returned to the Authorization Required screen. -
Page 15: Appendix A - Safety Information
Appendix A – Safety Information POWER SUPPLY Always use only the power supply unit that came with the Please read before use: device. You should immediately stop using the power supply unit if the cable or power supply unit is damaged. LOCATION This device is designed for indoor use only. -
Page 16: Appendix B - Set Ns-01 Ip Connectivity To Access Web Ui
Set NS-01 IP Appendix B – PRODUCT HANDLING connectivity to access Web UI Always treat your device and its accessories with care and keep it in a clean and dust-free place. Do not expose your device or its accessories to open flames. Do not drop, throw or try to bend your device or its If your CloudMesh Satellite NS-01 is currently not paired to a CloudMesh Gateway you will have accessories. - Page 17 In the Networking tab of the Ethernet Properties dialog box, go to the list of This From the Network connections page, right click on the connection that you had used to connect to the Gateway: connection uses the following items: ...
-
Page 18: Appendix C - Technical Specifications
Appendix C – Technical specifications The Internet Protocol Version (TCP/IPv4) Properties page appears: WIRELESS NETWORK IEEE 802.11 ac/n/g/a WIRED NETWORK 2 x Auto-sensing Gigabit LAN ports DIMENSIONS 113 (w) x 145 (h) x 110 (d) mm WEIGHT 320g POWER INPUT 100 V to 240 V/AC, 50/60 Hz TEMPERATURE Operating Temperature Range:... - Page 19 CloudMesh Satellite – NS-01 19 of 19 UG01221 v1.0 May 2020 © NetComm Wireless 2020...
Need help?
Do you have a question about the NetComm CloudMesh Satellite NS-01 and is the answer not in the manual?
Questions and answers