Getting Started - EL STG100EU Manual

•
If the skin in the tested area
appears normal and no
adverse effects are present,
you can proceed with a full
treatment at the highest
comfortable energy level
that you tested.
Note: The RF energy level
indicates the rate at which the
temperature rises when in
heating mode. A high RF
energy level will enable faster
and more even heating. You
can achieve maximum results
with all RF energy levels but
for lower levels it will take
more time to reach the
effective temperature.
Therefore, you may select any
RF energy level that you find
comfortable.

Getting Started

Step 1: Prepare your skin
1. Remove jewelery from the
treatment area, as well as
from your hands, prior to use.
2. Prior to use, make sure your
skin is dry, clean and free of
topical products such as:
moisturizers, liquids or lint.
3. Never use flammable liquids
such as alcohol (including
perfumes, sanitizers, or other
applications containing
alcohol) or acetone on the
skin one hour before using
the device as it may cause
burning of the skin.
4. The device is suitable for
men. However male users
should make sure their skin
is clean-shaven before
treatment.
Step 2: Device Operation
Note: A preliminary test should
be conducted separately for
each area you intend to treat
before proceeding with a full
treatment in that area. See
"Preliminary Test" section
above.
1. Make sure the device is
clean, dry and intact prior
to use.
2. Apply an even layer of
"Base Gel", included in your
kit, on the area of your skin
intended for treatment.
3. Set the Radio Frequency (RF)
energy level and the
massage speed to the level
you selected in your
preliminary test treatment.
Gently touch the RF energy
level selection button
repeatedly until you reach
the desired level: 1, 2, or 3.
Gently touch the massage
level button
until you reach the desired
level: 1 or 2.
repeatedly
13