Before Use; Installation; Operation - Eagle L330F Manual

These instructions should be read carefully and left with the user of the product for
future reference.
You must inspect the luminaire including its cable for any signs of damage. If the
product is damaged, DO NOT use it, and contact your supplier immediately.
Remove the fixing bracket from the body of the luminaire.
Attach the fixing bracket to a wall or post, using screws and, if necessary, wall plugs.
Fit the body of the luminaire into the fixing bracket.
Connect the luminaire to the electricity supply using the lead provided.
Brown = live
Blue = neutral
Green/yellow = earth
The luminaire must be earthed.
If mounting outdoors then make sure that the connections are adequately
waterproofed.
Connect to a lighting circuit fused at 6 Amps or lower, or to a ring main using a
fused spur fitted with a 5 Amp fuse.
Do not connect this luminaire to the output of a light dimmer.
Press the ON button to switch the luminaire ON.
Use the 16 coloured buttons to select one of 16 colours.
Press the
Press the
Press any one of the 16 coloured buttons to select a colour.
Press FLASH to select the colour-chase function
To select the strobe function select any colour, then press STROBE.
Press FADE to select the fade-between-colours function
Press SMOOTH to select the flash-and-change-colour.
In each of the FLASH, STROBE, FADE and SMOOTH modes, the
used to increase the speed, and the
speed.
IMPORTANT
Installer and Users please note:

BEFORE USE

INSTALLATION

OPERATION

button to increase the brightness.
button to decrease the brightness.
button can be used to decrease the
Page 2
button can be