teca AHP-1200MSP Installation

1) Carefully set the unit on it's back using the included insulating foam under the unit
to protect the power input module/switch.
2) Peel and remove the clear plastic film from the cold plate surface.
3) Carefully place the cold shoe assembly on the cold plate aligning the
(4) exterior holes on the cold shoe with the threaded inserts on the cold
plate. Make sure there is no foreign material between the cold plate
and the cold shoe.
4) Secure the cold shoe on the cold plate with (4) 6-32 x 5/8 socket head
cap screws, item #3142 & (2) 6-32 x 2 3/4 socket head cap screws, item
#4277. Tighten the screws using the provided Hex L-Key, item #4280.
Item #3142, 6-32 x 5/8
socket head cap screw
Cold Shoe Assembly
Item #4277, 6-32 x 2 3/4
socket head cap screw
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN INCHES DRAWN
TOLERANCES:
CHECKED
FRACTIONAL
ANGULAR: MACH BEND
PROPRIETARY AND CONFIDENTIAL
TWO PLACE DECIMAL
THE INFORMATION CONTAINED IN THIS
THREE PLACE DECIMAL
DRAWING IS THE SOLE PROPERTY OF
TECA CORPORATION.
ANY REPRODUCTION IN PART OR AS A WHOLE
INTERPRET GEOMETRIC
WITHOUT THE WRITTEN PERMISSION OF
TOLERANCING PER:
TECA CORPORATION IS PROHIBITED.
MATERIAL
FINISH
DO NOT SCALE DRAWING
NAME DATE
10/10/17
AA
AHP-1200MSP
COLD SHOE INSTALLATION
SIZE DWG. NO.
A
SK170710
S1098 SHEET 1 OF 3
REV