To Remove All Transmitters From The Device; To Add A New Transmitter - Deceptively Simple Cue Command Instructions Manual And User Manual

To remove all transmitters from the device

1. Connect the appliance to power.
2. With a straightened paperclip, press and hold
(LED lights solid but may be diffi cult to see) the
LEARN bu on on the bo om of the dock enclosure
(Illustra on #2) for approximately 11 seconds. If the
LED is fl ashing when released, the bu on was not
held long enough. Repeat the step.
3. Follow the procedure to add a transmi er.
To add a transmitter
1. With the same paperclip, press the LEARN bu on
on the bo om on the dock enclosure for one-
second and release. The yellow LED will start
fl ashing.
2. Press any bu on on the handheld transmi er.
The LED con nues to fl ash.
3. Press the LEARN bu on again on the dock
enclosure to complete the procedure. The LED
goes dark.
To verify the transmitter is functioning properly
1. Press one of the bu ons on the transmi er and
you'll see the light from the LED through the
portal. Every me the device receives a signal,
the LED will illuminate. Test all fi ve bu ons on the
transmi er to verify communica on.
6