Infinity PRTF-100 Manual

CUTTING TOOLS
Infinity Professional Router Table Fence
Part # PRTF-100
Congratulations on purchasing your Infinity Professional Router Table Fence. This fence is designed to fit any
router tabletop that has either a pair of ¾" x 3/8" miter T-tracks or ¼-20 T-tracks on 17" centers. It mounts
perfectly to all Infinity Professional Router Table Tops and packages including; RTP-103, RTT-027,
and RTT-047.
Parts List
A. Main Fence Assembly
B. Dust Collection Port
C. Adhesive Rule Set
D. Bit Guard Packet
a. 1x Bit Guard
b. 2x ¼-20 T-bolts
c. 2X Thumb Knobs
E. Mounting Knob Packet
a. 2x Tall Star Knobs
b. 2x ¼-20 T-bolts
c. 2x Miter T-track Adapters
F. Offset Bar Packet (Not Pictured)
a. 1x 1/8" Offset Bar
b. 1x 1/16" Offset Bar
G. Hardware Packet (Not Pictured)
a. 4x, ¼-20 x 3/8" Button Head Hex Drive Screws
b. 4x, ¼" Brass Washers
c. 4x, ¼-20 Oval Nuts
d. 8x, ¼-28 x ¼" Set Screws
e. 1x, 1/8" Allen Wrench
f. 1x, 5/32" Allen Wrench
g. .02oz Thread Locker
Step 1. Install the Dust Port
Remove the outfeed fence assembly by loosening the two bar knobs and slide the assembly off the base. Install
the 3/8" long screw (a), brass washers (b), and oval nuts (c) loosely into the holes in the dust port. Slide the dust
port onto the base until centered over the router bit cutout and tighten screws with the included Allen wrench
(f). Reinstall the outfeed fence assembly.
P: 813-881-9090 | 1-877-872-2487 - Order Online 24/7: InfinityTools.com
™
A
Outfeed
D
310 Mears Blvd • Oldsmar, FL 34677
E
B
Infeed
C