Calling With Intele-Menu Commands; General Procedure; Step-By-Step Instructions - Ultratec INTELE-MODEM How To Use Manual

CALLING WITH INTELE–MENU COMMANDS

General procedure __________________________________________

Set up your hardware, turn on the computer and modem, and load your communications
software. Enter terminal mode. The communications program instructions will show you
how to get into terminal mode (sometimes called "talk" or "on-line" mode).
1. Press the Escape Key and then the Spacebar to enter command mode. The
Intele–Modem will display the following prompt on your computer screen:
Command (Press ? for help):
2. Type the letter or number for the command you want (or type ? to see the
Help Menu). Commands are described starting on page 9.
3. Press the Enter Key to return to on-line mode and carry on your
conversation.
If you don't see the Command Line when you press the Escape Key and the Spacebar, try
typing ATZ first. See the Problems and Solutions section on page 21 for more information.

Step-by-step instructions_____________________________________

Modem settings
When you follow these instructions, you will be using the following modem settings:
• Automatic communication mode. The modem will use either ASCII or
Baudot code, depending on what it receives from the other computer or TTY.
• Half-duplex
• Pulse dialing
Instructions
1. Turn on your computer.
2. Start up your communications software.
3. Turn your Intele–Modem on. The POWER, BDT, and LO lights on the front
panel of your modem will go on.
INTELE-MODEM
POWER
4. Follow your software instructions to get into terminal mode.
5. Press the Escape Key and the Spacebar.
6. Type D and the telephone number you want to dial. If you make a mistake,
use the Backspace Key to make corrections.
BDT ASC HI LO CD RXD
CODE SPEED COMMUNICATION
TXD OH SIG
PHONE
CALLING WITH INTELE-MENU COMMANDS • 5
Turning on the
Intele–Modem lights
the Power, Baudot and
Low Speed indicators.