H&S TS 400 Operating And Maintenance Recommendations

READ THOROUGHLY AND UNDERSTAND THIS PUBLICATION BEFORE ATTEMPTING
TO OPERATE THE EQUIPMENT.
DANGER!
The application of this product requires an exposed rotating cutting blade. It
produces HOT, SPARKS requiring that eye, ear, and hand protection and other
appropriate protective clothing be worn at all times. Do not wear loose fitting clothing
that may become entangled with the rotating objects.
Outside Panel
Arbor and
Bolt
Guide Rail
Connector
Weld Tabs with
Line Indicators
1. Remove guide rails from the shipping tube.
Loosen the weld tab screws with the wrench
provided and swing them to a position that is 90
to the guide rail. Tighten the tab screws.
relocate the tab to a suitable locator hole.
P.O. Box 393
Wadsworth, OH 44282, U.S.A.
Tel: +1 330 336 4550
Fax: +1 330 336 9159
www.hstool.com
Saw Power Unit
with Carriage
Panel
Blade
Bracket
Lock
Recommended Setup Procedure
2. Establish your cut line
and set the weld tab
assembly against the
panel. The top of the line
indicator must be on the
cut line. If the weld tabs
are not at a place where
they can be welded,
remove the tab bolts and
OPERATING and MAINTENANCE
RECOMMENDATIONS
for MODEL TS 400
Membrane Removal Blade,
Outside Membane Arbor and Bolt
Membrane
Slitting Bracket
Carriage
Lock
Weld Tab Screws
o
screw provided. Weld additional tabs into place.
without being so loose that it will affect the
cutting accuracy.
Blade Arbor
Wrench Weld Tab
Wrench
Guide Rail
3. Weld the tabs in
position and check for
cut line accuracy. Do not
remove the line indicator
unless it needs
replacing. Additional
guide rail sections can
be added for longer cuts.
Slide the male connector into
the next guide rail section and
bolt them together with the cap
4. Mount the saw power
unit/carriage assembly
onto the guide rail.
Align the guide shoes
with the top and bottom
of the guide rails. It
should slide easily