Advertisement
Quick Links
Advertisement
Summary of Contents for Kitables SOLAR USB CHARGER
- Page 1 SOLAR USB CHARGER kit instructions...
-
Page 2: Kit Includes
Solar USB Charger Kit Instructions Getting Started Kit Includes: (a) Laser Cut Box (e) USB Booster 1. Check your parts list (b) Switch (f) Solar Cell 2. Read through instructions (c) Lipo Battery (g) Rectifying Diode (d) Charging Module (h) Wires 3. Gather your tools. 4. Glue together frame. - Page 3 Solar USB Charger Kit Instructions Build Case Before soldering, push switch into port on the side of the wood box from the outside in. It should fit snugly, but if you Switch need glue, apply a small amount to the edge.
-
Page 4: Wiring Diagram
Solar USB Charger Kit Instructions Start Connecting Wires Solder 1 red wire to the (+) terminal and 1 LIPO black wire to the (-) terminal on the back BATTERY of the solar panel. Some kits might have the B/Out as one terminal. In that case, combine wires together. Wiring Diagram... - Page 5 Solar USB Charger Kit Instructions Solder the Rectifying Diode to the Red wire Pull these wires through “top” panel of the coming from the solar panel, the black line wood box. Glue panel to the wood. on the diode faces away from panel. The diode serves as a valve for electricity to travel in one direction.
- Page 6 Solar USB Charger Kit Instructions Connect the wires from the Solar Panel to Cover the diode and wire with Heat the Micro USB Charging Module (blue Shrink tubing. Use a heat gun or board). This will connect your Panel to soldering iron edge to shrink tubing over the Battery.
- Page 7 Solar USB Charger Kit Instructions On the Blue Micro USB Board, attach (and Connect your battery to the other end of solder) a Red wire to the OUT+ terminal and a the Micro USB Module (blue board). The Black Wire to the OUT- terminal.
- Page 8 Solar USB Charger Kit Instructions Solder the available Red wire from charging module (blue board) to the (IN+) terminal on the USB Booster (green board). Next connect the Switch to the IN- terminal on the USB Booster (green board) with a Black Wire.
- Page 9 Solar USB Charger Kit Instructions Attach the available Black Wire from the Your completed circuit should Micro USB Module (blue board) the other look something like this: Switch Terminal.
- Page 10 Solar USB Charger Kit Instructions Secure components to case with glue or other adhesive. We recommend using a hot glue gun for added adhesive, these ports will experience repeated use. Gently stuff the wires and battery into the Glue case. It can be helpful to glue the wires...
- Page 11 Solar USB Charger Kit Instructions Charging You have now completed a Kitables Kit! If you have questions, check out our FAQ at Set panel in sunlight, it takes Kitables.co or email us at approximately 14hours to fully charge info@kitables.co LiPo battery. Or, plug a micro USB cable...
Need help?
Do you have a question about the SOLAR USB CHARGER and is the answer not in the manual?
Questions and answers