Scallywag Kids STARTER BED Assembly Instructions

Please read & check through these instructions carefully before proceeding with assembly
Box 1 of 4 End Panels
Box 2 of 4 Bed Rails
Box 3 of 4 Bed Legs
Box 4 of 4 Bed Slats
Tools Required (Not Supplied)
Ends Assembly Components:
Box 1 & Box 3
Fittings Pack (End Assembly)
(A) 8mm Dowel Qty = 12
(B) Cam Pin Qty = 8
(C) Cam (Already In Panel) Qty = 8
1)
1) Place legs on a flat surface taking care not to scratch. Insert 8mm dowels (A) into holes with light
hammer.
Screw cam pins (B) carefully into 5mm holes, to top of the thread, using cross slot screwdriver.
Repeat process for the other three legs.
2) Ensure cams (C) are inserted in the panel with the arrow pointing to the edge. Carefully locate the
panel onto the dowels and cam pins. When in place, turn the cam clockwise with cross-slot screwdriver to
lock.
Ensure the legs are attached to the panel in pairs ie: dowel holes are facing the same way.
STARTER BED ASSEMBLY INSTRUCTIONS

COMPONENTS

2 x End Panels with 8 Cams Inserted
2 x Side Rails (with Rib)
2 x Long Safety Rails
2 x Short Safety Rails
1 x Support Leg
1 x Fittings Pack (Bed Assembly)
2 x Right Handed Legs
2 x Left Handed Legs
1 x Fittings Pack (End Assembly)
1x Set of Slats

1 - Ends Assembly

A
B
A
B
A
2)
A
B
Dowel Holes
PANEL
Cam C
A