(operators in workplaces, museums or events users, etc.) and the tracing of contacts in the post- emergency management phases of the Covid-19 pandemic. The Pj20 tracer device, when worn by an operator, is able to detect other nearby devices. When two or more operators approach each other, the device emits alarm signals based on the estimated distance, with the possibility of configuring alarm modes (LED, sound, vibration) and associated distance.
Page 4
Classification: Restricted Pj20 tracer Manuale utente Figure 1 - Login Figura 2 – Start scan Rev 0.1 draft of 18.05.2020 Page 4 of 15...
Page 5
Classification: Restricted Pj20 tracer Manuale utente Figure 3 – Device list By clicking on "Initialize" the device is initialized, while through the "Initialize & Configure" button (Figure 4 - Initialization and configuration), it is possible to configure the following operating parameters (Figure 5 - Operating parameters): •...
Page 6
Classification: Restricted Pj20 tracer Manuale utente Figure 4 – Initialization and configuration Figure 5 – Operating parameters Rev 0.1 draft of 18.05.2020 Page 6 of 15...
Page 7
Classification: Restricted Pj20 tracer Manuale utente The devices updated to the latest firmware version can be assigned to a group by entering a numeric value from 1 to 255 via the "Set group" command (Figure 6 - Set group). The default group is set to 0 and all tracers generate alarm signals and track contacts.
Classification: Restricted Pj20 tracer Manuale utente o Black: the device has been deactivated by pressing and holding the red button on the device for 3 seconds (when pressed, two yellow LED flashes will follow). • Battery Voltage Tag: indicates the device battery charge status;...
In general, to improve performance, it is recommended to wear the devices at the same height. When two (or more) Pj20 tracer devices approach each other, they will notify the potential warning condition.
Page 10
Classification: Restricted Pj20 tracer Manuale utente About 15000 contact events (30 days, with one contact per minute) can be saved in the device internal memory (128 kB). Rev 0.1 draft of 18.05.2020 Page 10 of 15...
Do not use the device in potentially explosive atmospheres. The presence of flammable gases or fumes constitutes a serious safety hazard. Vetrya S.p.A. disclaims any responsibility for damage caused by inadequate use of the device and by failure to observe the warnings contained in this document.
Page 12
Classification: Restricted Pj20 tracer Manuale utente DO NOT power the device with batteries other than the one shown in the table. The use of different batteries is potentially dangerous. The replacement of the batteries must be carried out by technical personnel. To replace the battery, a Torx screwdriver is required.
Classification: Restricted Pj20 tracer Manuale utente • DO NOT put batteries in your mouth. If the battery (or the liquid it contains) is swallowed, contact a doctor immediately. The swallowed battery must be immediately removed. The ingestion of the battery or the liquid contained in it causes irreversible damage to the digestive system, within two hours, until death;...
The information contained therein was obtained from sources that Vetrya S.p.A. considers reliable and accurate to the best of the Company's knowledge. This sheet is not intended to be an exhaustive document on global hazard definition regulations.
Manuale utente 3. EU D ECLARATION OF ONFORMITY Vetrya S.p.A. declares that the Pj20 tracer device complies with the European directives 2014/53/UE (RED) and 2011/65/UE (RoHS 2). The Pj20 tracer product complies with the following standards: • ETSI EN 301 489-1 v2.2.3 + ETSI EN 301 489-17 v3.2.2 draft •...
Need help?
Do you have a question about the Pj20 tracer and is the answer not in the manual?
Questions and answers