Devanco Canada Marantec M3-2312 Instructions

Transmitters
Instructions
FEATURES
A family of state-of-the-art transmitters, each transmitter is
custom encoded and ergonomically designed to be an integral
part of your garage door opener system, with two styles to suit
your personal preference:
Mini (2- or 4-channel)
Micro (3-channel), the smallest transmitter of its kind.
1. Using the Transmitter
All transmitters come with batteries already installed.
To open or close garage door, press and hold the button (Mini
and Micro transmitters have indicator lights). When garage
door begins to move release button.
To stop the garage door during travel, press and hold button
until door stops, then release button.
To continue the garage door travel after stopping it, press and
hold the button. Press button once, the door will travel in the
opposite direction.
2. Transmitter Mounting
The transmitters can be convenietly mounted on the wall (fig.
1A) using the mounting plate (optional) or inside your car using
the visor clip (fig. 1B). These two mounting alternatives (fig. 1A
and fig. 1B) are available with Mini models only. The Micro can
be used with the key ring attachment (fig. 1C).
Mounting Plate (fig. 1A)
The mounting plate enables you to mount the transmitter easily
to the wall or other area.
Secure the mounting plate to area using screw and anchor
(not provided).
Slide the transmitter into the mounting plate, which will hold
it firmly in place.
Visor Clip (fig. 1B)
The visor clip allows for easy mounting of the transmitter to a
car visor.
Snap visor clip into transmitter.
Note: If you do not need the visor clip, install the visor
compartment cover.
Key Ring Attachment (fig. 1C)
The key ring attachment permits easy mounting of the Micro
to a key ring.
Open the Micro by using small coin.
Snap in the key ring attachment.
Close the transmitter.
3. Battery Replacement
The installation of the battery for Mini and Micro is the same.
When replacing batteries follow the steps below:
Open the transmitter by using small coin.
Insert a 3V battery (type CR2032) as shown.
Close the transmitter.
Note: Replace batteries with same type only.
For more information, please visit www.devancocanada.com or call toll free at 855-931-3334
for models: M3-2312, M3-2314, M3-3313
(Figure 1)
(Figure 2)
Figure 1. Mounting Plate & Visor Clip
fig. 1A
Mounting Plate
(optinal)
fig. 1B
Visor Clip
fig. 1C Key Ring Attachment for Micro Transmitter
Key Ring
Attachment
Figure 2. Battery Compartment
Coin
Battery
Visor Compartment
Cover