Bestron AAC7000 Instruction Manual page 35

USAGE - Setting the mode
The device has three operating modes, with which you can ventilate, dehumidify, and cool the room.
Ventilating
1. Press the button "
mode
functioning as ventilator.
2. Press the button "
speed
up at " " (low speed) or "
low
Dehumidifying
1. Press the button "
mode
The device switches to the lowest speed, and will now dehumidify the air.
ATTENTION:
• When the internal water collection tray is full, the device stops functioning, and the indication light lights
up on the control panel at "
continue using the device (see 'CLEANING AND MAINTENANCE – Water drainage').
• If you often use the device to dehumidify the air, you can also use the continuous drainage (see
'CLEANING AND MAINTENANCE – Water drainage').
Cooling
1. Press the button "
mode
The device is now functioning as air cooler, and will cool the air by means of a cooling element.
2. Use the buttons " " (d) and "
up
3. Press the button "
speed
lights up at " " (low speed) and "
low
USAGE - Sleep function
The device has a sleep function. If you turn on this function, the device will operate in its most silent and
energy saving mode. Attention: the sleep function only works in the "COOL" mode
1. Press the button "
sleep
most energy saving mode.
2. Press the button "
sleep
USAGE - Timer function
The device has a time switch with which you can automatically turn the device on or off at the end of a set
time.
Automatically turning on
When the device is turned off:
1. Press the button "
timer
2. Use the buttons " " (d) and "
up
3. Wait until the display (a) stops flickering. The switch-on time is set.
4. Press the button "
timer
5. Press the button "
timer
Automatically turning off
When the device is turned on:
1. Press the button "
timer
2. Use the buttons " " (d) and "
up
3. Wait until the display (a) stops flickering. The switch-off time is set.
4. Press the button "
timer
5. Press the button "
timer
" (figure 1, g), until the indication light lights up at "
" (c) to change between low or high speed exhaust air. The indication light lights
" (high speed).
high
" (figure 1, g) once or multiple times, until the indication light lights up at "
". You have to empty the water collection tray before you can
water full
" (figure 1, g) once or multiple times, until the indication light lights up at "
" (e) to set the cooling temperature between 16°C and 31°C.
down
" (c) to switch between a low or high speed of exhaust air. The indication light
" (high speed).
high
" (figure 1, f) to turn on the sleep function. The device switches to the lowest and
" again to turn off the sleep function.
" (figure 1, b). The display starts to flicker.
" (e) to set the switch-on time between 1 and 24 hours.
down
" again to adjust the switch-on time if desired.
" again to turn of the timer function.
" (figure 1, b). The display starts to flicker.
" (e) to set the switch-off time between 1 and 24 hours.
down
" again to adjust the switch-off time if desired.
" again to turn of the timer function.
35
EN
". The device is now
fan
".
dehum
".
cool