Advertisement
Table of Contents
Toyota Highlander Installation Instructions
Part #: SS1232
Fits: 2014 - 2016
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT.
READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
**DO NOT OVER TORQUE. STANDARD OPERATING LOAD FOR TIGHTEN BODY MOUNT NUTS & BOLTS VARIES FROM 45 TO 65 FOOT POUND.
Qty
1
Driver / Left Running Board
1
Passenger / Right Running Board
2
Front Mounting Bracket Arms
2
Rear Mounting Bracket Arms
2
Middle Mounting Bracket Arms
2
8mm x 15mm x 60mm T-Bolts
6
8mm T-Slot Nuts
2
6mm Black Latches
8
8mm Lock Washers
Part Description
PARTS LIST
Qty
6
8mm x 19mm Hex Bolts
10
5mm x 20mm Hex Bolts
2
6mm x 30mm Hex Bolts
2
5mm Black Screws
2
6mm Bolt Nuts
8
8mm Bolt Nuts
2
6mm Flat Washers
8
8mm Flat Washers
2
6mm Lock Washers
Part Description
Advertisement
Table of Contents
Summary of Contents for TRQ SS1232
- Page 1 Toyota Highlander Installation Instructions Part #: SS1232 Fits: 2014 - 2016 REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. **DO NOT OVER TORQUE. STANDARD OPERATING LOAD FOR TIGHTEN BODY MOUNT NUTS & BOLTS VARIES FROM 45 TO 65 FOOT POUND.
- Page 2 INSTALLATION PROCEDURE 1. Identify and separate the driver and passenger side front and rear Mounting Brackets. Start installation on the driver / left side of the vehicle. 2. Remove the plastic side skirt in order to reveal the holes for the brackets to screw into. 3.
- Page 3 7. The holes indicated with a blue star / star; ensure that one middle bracket has a large hex bolt with a hex nut attached, let’s call it Middle Bracket A. Then ensure that the other one does not have any bolts or nuts on it, let’s call this one Middle Bracket B.
- Page 4 Figure 8: Side A (Front) Figure 9: Side B (Rear) 10. On the rear bracket, make sure you have a pair of 6mm Black Latches, 6mm x 30mm Hex Bolts, 6mm Bolt Nuts, 6mm Flat Washers, and 6mm Lock Washers for each side. These will be used to tighten the bracket in place to prevent it from moving about.
Need help?
Do you have a question about the SS1232 and is the answer not in the manual?
Questions and answers