Sidebar Duo Manual

SIDEBAR DUO & LT6500
Congratulations!! You are now the proud owner of a SIDEBAR Beverage System. This
electronically controlled system will provide years of trouble-free service when properly
installed.
Please read the directions carefully.

GETTING STARTED

I. COMPONENT LOCATIONS
1.) Determine the location of your Dispensing Tower (If installing the Duo, be sure to
plan accordingly for beer supply locations). Check for obstructions under or behind your
mounting surface (pull out drawers may need modified in some cases).
2.) Determine the location of the pump unit (should be in a dry location). The pump unit
will need to be installed below the Dispensing Tower and above the tops of the supply
bottles. For best performance, keep the pump unit as close to the bottles as possible. The
distance from the pump unit to the tops of the bottles should not exceed 8 inches.
II. TOWER (SIDEBAR LT6500 & SIDEBAR DUO) INSTALLATION
1.) Once you have determined the exact location of the tower, drill a 1.25 inch diameter
hole for the supply lines and control cable opening. This location should be in the center
of where the tower will be installed.
2.) Feed the beverage supply lines through the 1.25 inch opening.
3.) Using a pencil or marker, mark the four holes at the base of the tower, make certain
the tower is properly faced forward and centered over the 1.25 inch opening.
4.) Once the Tower is in the appropriate location and the holes have been marked,
remove the tower and drill a 7/32" pilot hole at each of the four markings. NOTE:
granite, tile or stone surfaces may need professional drilling to prevent damage to the
counter surfaces.
5.) Place the provided rubber gasket over the drilled holes; feed the supply lines through
the 1.25 inch opening and place the Tower correctly over the gasket and pilot holes.
Using the provided stainless steel mounting screws, secure the tower the surface. Use
care not to "strip" the screw heads.
Page 1
www.supersidebar.com