Operating The K-Metron; Turning The Unit On & Off; Coupling The Sensor Head With The Calibrated Magnet - 493K K-METRON User Instructions

1 OPERATING THE K-METRON

1.1 Turning the unit ON & OFF
To turn the unit ON momentarily press the ON/OFF switch on the face of the K-METRON
until the left-hand POWER LED illuminates. Battery level will be checked each time the unit
is turned on, and if a low battery voltage is detected then a warning will be displayed on
start up.
To turn the unit OFF press the ON/OFF switch on the face of the K-METRON unit the POWER
LED goes off.
Visual Display
Power LED
Delete Last
Transmitted
Data
The unit will auto power off after 3 minutes of inactivity. A warning "PWR OFF" is displayed
after 1 minute of inactivity. The unit can be interrupted from auto power off by pressing
either the orange trigger or the DELETE button; pressing either will only interrupt the auto
power off and will neither 'transmit' or 'delete' any data.
1.2 Entering the Configuration Menu
To enter the configuration menu, with the K-METRON turned off, hold down the DELETE
button and switch the unit on. While continuing to hold down the DELETE button, the
display will read "Wait ... Setup mode". Once the display reads "M1: Cal Object" release the
DELETE button. The unit is now in the Configuration Menu. To scroll through each menu use
the DELETE button; to select use the Orange Trigger Button.

1.3 Coupling the Sensor Head with the Calibrated Magnet.

Place the Sensor Head on one face of the product that is to be measured. Hold or place the
magnet on the opposite side of the product wall until it couples to the sensor head.
3 | P a g e
K-METRON Radio User Instructions (Firmware 2.3.4; Doc v3.0.0)
Sensor Head Dock
Sensor Head
ON/OFF
Switch