afx light faze700 User Manual

Faze machine 700w
Hide thumbs Also See for faze700:
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the faze700 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for afx light faze700

  • Page 2 © Copyright LOTRONIC 2019...
  • Page 5: Dmx Connector Pin Assignment

    • Place the feeder tube with filter deep inside the full fluid tank (Figure 1-D). Use definitely water based liquid of good quality; • Plug mains power cord from the faze machine into appropriate power supply socket. Wait about 75 seconds for heating element to heat up; •...
  • Page 6: Manual Operation

    d.xxx: Setting duration of timing fogging(Duration=3~250s). i.xxx: Setting interval of timing fog- ging(Interval=5~250s). UP: Button for increasing numerical value DOWN: Button for decreasing numerical value ENTER: Starting button of fogging, release to stop. Please note: • Self-cleaning function: The machine design of machine stops working after a delay of 30 se- conds, automatically clear the tubing of the remaining liquid.
  • Page 7: Remote Control Operation

    • If desired, connect another faze machine: Plug one end of another signal cable in to the output socket (Figure 1-J) on the back of the first FAZE700; plug the other end of the signal cable to the input socket (Figure 1-I) on the back of the second FAZE700. Follow the same procedure to link more fog machine, if desired;...
  • Page 8: Troubleshooting

    when fog value is adjusted to 100%, the software will adjust wind value (even it is set at 5%) to 30% automatically; when wind value is adjusted to 5%, the software will reduce fog value to 50% automatically. This will prevent the smoke vent from getting humid because of too small wind but too much fog.
  • Page 9: Important Note

    The DJ DMX Faze Machine is designed with volume adjustable controller. Detail operation as bel- lows; 1. Firmly attach the remote control to socket (Figure1-K) on the back of the FAZE700. The red LED (power) on the remote control will light up;...
  • Page 10: Specifications

    SPECIFICATIONS Power supply ......................220-240V~50/60Hz Consumption ........................... 720W Fuse ............................T5A/250V Heating element ..........................700W Heat-up time ..........................90 sec. Fluid consumption ..................10ml/min. at max. output Faze volume ............................ 255m Tank ................................. 2l Dimensions ......................378 x 317 x 310mm Weight ..............................
  • Page 13: Fonctions Des Touches

    6. Contrôlez la machine à l’aide de l’afficheur LCD ou branchez un contrôleur DMX. Ou bien connec- tez la télécommande filaire sur la fiche (Figure 1-K) à l'arrière de l'appareil. 7. Reportez-vous au chapitre sur la télécommande (Appendix A).. AFFECTATION DES BROCHES DU CONNECTEUR DMX La machine possède des connecteurs à...
  • Page 14: Fonctionnement Manuel

    ▲: Bouton pour augmenter la valeur numérique ▼: Bouton pour baisser la valeur numérique ENTER: Bouton Marche/Arrêt pour l’émission programmée et continue Note importante: • Fonction auto-nettoyante: La machine s’arrête automatiquement après 30 secondes et nettoie les tuyaux. • Les valeurs entrées sont sauvegardées automatiquement. Observations importantes: Pour éviter que la sortie de brouillard ne devienne humide, le logiciel détectera la valeur du flux d'air et la valeur du brouillard et effectuera les changements nécessaires.
  • Page 15: Fonctionnement De La Telecommande

    (Figure 1-J) au dos de la première FAZE700; branchez l'autre extrémi- té du câble signal sur la fiche d'entrée (Figure 1-I) au dos de la deuxième FAZE700. Procédez de la même manière pour relier plus de machines.
  • Page 16 à faire fonctionner la FAZE700 avec votre contrôleur DMX. ATTENTION Pour éviter le risque que la sortie de brouillard devienne humide, le logiciel détectera la valeur du flux d'air et la valeur du brouillard et effectuera les ajustements nécessaires. En mode de contr^^ole par l'afficher (fonctionnement programmé, continu et manuel) ou en mode DMX:...
  • Page 17: Note Importante

    1. Branchez la télécommande filaire fermement sur la fiche (Figure1-K) au dos du FAZE700. Le voyant rouge sur la télécommande s'allume; 2. L'afficheur à LED de la FAZE700 indique P.xxx , la génération de fumée commandé par l'afficheur s'arrête et est maintenant contrôlé par la télécommande; f 3.
  • Page 18: Caracteristiques Techniques

    A: Jack 6.35 B: Bouton rotatif C: LED verte D: LED rouge CARACTERISTIQUES TECHNIQUES Alimentation ......................220-240V~50/60Hz Consommation ..........................720W Fusible ............................T5A/250V Corps de chauffe ..........................700W Temps de chauffe .......................... 90 sec. Consommation de liquide ..............10ml/mn. à pleine puissance Volume de brouillard ........................
  • Page 19 www.afx-light.com...
  • Page 20 © Copyright LOTRONIC 2019...

This manual is also suitable for:

15-1739

Table of Contents