NEVER LEAVE DEHUMIDIFIER UNATTENDED WHILE CONNECTED TO A POWER SOURCE Operation Starting the Dehumidifier: 1. Connect the dehumidifier to the proper Automatic Mode (AU) electrical power. – Automatic mode will keep the ambient 2. Press power button to turn on the unit. humidity constant in relation to the ambient 3.
Page 4
NEVER LEAVE DEHUMIDIFIER UNATTENDED WHILE CONNECTED TO A POWER SOURCE Operation Timer: – The timer can be set for 1-24 hours. Automatic Shutdown – The timer can turn the unit it on while in – With the dehumidifier plugged in and standby mode or turn the unit off after a operating, press the timer button until the period of use.
NEVER LEAVE DEHUMIDIFIER UNATTENDED WHILE CONNECTED TO A POWER SOURCE Maintenance Draining: Water Tank Draining – The condensed water will drain into the tank in the rear of the dehumidifier. – When the tank is full, the tank full indicator light will illuminate.
NEVER LEAVE DEHUMIDIFIER UNATTENDED WHILE CONNECTED TO A POWER SOURCE Plug Replacement WARNING RISK OF ELECTRIC SHOCK! DISCONNECT FROM POWER BEFORE MAINTENANCE. NOTE: This section only applies to heaters sold or used in Great Britain. This appliance is supplied with a BS1363 3 pin The blue wire must be connected to the terminal marked with an N or colored black.
Need help?
Do you have a question about the ST-12L-DH-E and is the answer not in the manual?
Questions and answers