Assembly Instructions - Blue Rhino UniFlame NPG2301-C Owner's Manual

Assembly Instructions

DO NOT RETURN PRODUCT TO STORE.
For assistance call 1.800.762.1142 toll free . Please have your owner's manual and serial
number available for reference .
For Easiest Assembly:
• To avoid losing any small components or hardware, assemble your product on a hard level
surface that does not have cracks or openings .
• Clear an area large enough to layout all components and hardware .
• When applicable, tighten all hardware connections by hand first . Once the step is
completed, go back and fully tighten all hardware .
• Follow all steps in order to properly assemble your product .
Step
Unfold legs
1
Unfold legs by pulling ring out and swinging leg out until it locks in place .
Step
Attach side handles
2
A . Attach handle, ignitor and heat plate support to right side of bowl using 2 sets
of small washers (C), small lock washers (F), wing nuts (B) and 1 heat resistant
washers (E) .
B . Attach handle to left side of bowl using 2 sets of small washers (C), small lock
washers (F) and wing nuts (B) .
Outdoor LP Gas Barbecue Grill Model No. NPG2301-C
Step
Attach heat shield, burner, regulator and ignitor wire
3
A . Feed ignitor wire through opening in bowl .
B . Attach heat shield and burner to bowl with large washer (D), large lock
washer (G) and wing bolt (A) .
C . Screw regulator clockwise onto burner stem .
D . Pull ignitor wire into ignitor .
WARNING: To avoid electrical shock, inspect before each use to make
sure the igniter and wire are fully connected.
Step
Attach lid handle
4
Attach handle to lid using 2 sets of small washers (C), small lock washers (F) and
wing nuts (B) .